Sliding Properties of Composite Sprayed Coating between Bronze Powder and Solid Lubricant

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Wear resistant solid lubricant coating made from PTFE and epoxy

A composite coating of polytetrafluoroethylene and epoxy shows 100 · improvements in wear resistance as compared to either of its constituents alone and reduced friction coefficient under testing on a pin-on-disk tribometer. This coating is made by impregnating an expanded PTFE film with epoxy, which provides three unique functions: (1) the epoxy compartmentalizes the PTFE nodes, which is belie...

متن کامل

Effect of morphology and nonbounded interface on dielectric properties of plasma sprayed BaTiO3 Coating

In this research, BaTiO3 thick deposit has been successfully sprayed by air plasma spray. The microstructure and dielectric properties of thick films were investigated by secondary electron microscopy (SEM) and LCR meter respectively. XRD measurement was carried out on plasma sprayed BaTiO3. The results illustrate differences in the crystal structure between plasma sprayed coatings and feed sto...

متن کامل

Quantification of a Lubricant Transfer Process that Enhances the Sliding Life of a MoS2 Coating

A lubricant transfer process that enhanced the wear life of a MoS2 coating has been identified and quantified. A steel ball sliding against a coated steel flat in reciprocating motion produced reservoirs at the turnaround part of the track ends, then emptied them, to provide replenishment similar to what is expected of liquid lubricants. The dynamics of the process were inferred from measuremen...

متن کامل

Sliding-induced Microstructure of Cold-Sprayed Copper Coating Observed by Electron Channeling Contrast Imaging

Cold gas dynamic spray is a coating process for fabrication of materials that are sensitive to heat and oxidation such as copper [1]. In cold spray, the particles are accelerated to supersonic velocities typically between 500 1200 m/s [1]. Upon high speed impact, the cold sprayed particles undergo extensive plastic deformation at very high strain-rates (up to 10 9 s -1 near impact interfaces), ...

متن کامل

Microstructural and Chemical Analysis of AgI Coatings Used as a Solid Lubricant in Electrical Sliding Contacts

AgI coatings have been deposited by electroplating on Ag plated Cu coupons. Electron microscopy shows that the coatings consist of weakly agglomerated AgI grains. X-ray diffraction, differential scanning calorimetry, thermogravimetry and mass spectrometry show that the AgI exhibits a reversible transformation from hexagonal to cubic phase at 150 °C. AgI starts to decompose at 150 °C with an acc...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: MATERIALS TRANSACTIONS

سال: 2003

ISSN: 1345-9678,1347-5320

DOI: 10.2320/matertrans.44.1024