Slide and ball finishing burnishing of aluminium alloy surface after milling
نویسندگان
چکیده
منابع مشابه
Dynamic modelling of hardness changes of aluminium nanostructure during mechanical ball milling process
In this research, the feasibility of using mathematical modelling in the ball milling process has been evaluated to verify the hardness changes of an aluminium nanostructure. Considering the model of normal force displacement (NFD), the radius of elastic-plastic and normal displacement of two balls were computed by applying analytical modelling and coding in MATLAB. Properties of balls and alum...
متن کاملFormation of glassy Ti50Cu20Ni24Si4B2 alloy by high-energy ball milling
The elemental powder mixtures with a nominal composition of Ti50Cu20Ni24Si4B2 can be amorphized under high-energy ball milling. A well-defined glass transition before crystallization appears in the obtained amorphous phase during heating in a differential scanning calorimeter. Awide supercooled liquid region DTx is available to be about 57 K. Crystallization of the ballmilled amorphous phase wa...
متن کاملAnalysis of Surface Roughness and Micro-hardness in Roller Burnishing of Aluminum Alloy 6061
Burnishing is a chip-less finishing process, in which a hard roller or ball presses the surface layer of part to perform plastic deformation in the surface layer and produce improved finish, enhanced hardness and compressive residual stresses on the surface of special materials such as Aluminum and Brass. In the following research, the effect of input parameters such as feed rate, cutting speed...
متن کاملPositron Lifetime Measurements of Subsurface Region in Aluminium Alloy and Aluminium Alloy Composite after Dry Sliding
This paper presents positron lifetime studies of the subsurface region of AK12 aluminium alloy and Al2O3-particle-reinforced AK12 aluminium alloy composite after sliding against steel in the pin-on-disc machine. The defect depth profile detected in the AK12 alloy extended up to 300 μm but for the composite AK12 the range of this profile was significantly shortened to less than ∼ 90 μm. The posi...
متن کاملModeling and Analysis of CNC Milling Process Parameters on Aluminium Silicate Alloy
With the increasing demands of high surface irregularities and machining of composites, conventional machining processes are now being replaced by high speed Computer Numerical Control (CNC) machines. In this paper aluminium silicate made from alloying aluminium and silicon oxide made from rice husk are used. The machining of the alloy on CNC machine is carried out. In addition to speed, feed a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mechanik
سال: 2016
ISSN: 0025-6552
DOI: 10.17814/mechanik.2016.5-6.71