Slag-Metal Equilibria between Liquid Copper and Calcium Ferrite Slag
نویسندگان
چکیده
منابع مشابه
Recovery of Copper from Copper Slag and Copper Slag Flotation Tailings by Oxidative Leaching
Copper smelter slag and copper smelter slag flotation tailings were leached using sulphuric acid solutions, without or with the addition of either ferric sulphate or hydrogen peroxide. Copper extraction from the slag was typically found to be twice as high as that from the slag flotation tailings. Hydrogen peroxide was determined to be the best lixiviant. Thus, copper and iron extractions were ...
متن کاملThermodynamic Investigation of Copper Removal From Liquid Slag.
The removal of copper dissolved in liquid stags by pyrometalIurgical means such as gaseous reduction and sulfidization is thermodynamically investigated. The lowest level possible for copper content is theoretically determined and compared. The results show that gaseous reduction is not as effective as sulfidization. Slags with very low levels of dissolved copper can be obtained with sulfide tr...
متن کاملSlag Behavior in Gasifiers. Part II: Constitutive Modeling of Slag
The viscosity of slag and the thermal conductivity of ash deposits are among two of the most important constitutive parameters that need to be studied. The accurate formulation or representations of the (transport) properties of coal present a special challenge of modeling efforts in computational fluid dynamics applications. Studies have indicated that slag viscosity must be within a certain r...
متن کاملInvestigation of Rutting Performance of WMA Mixtures Containing Copper Slag
Copper slag (CS) is an abrasive blasting grit made of granulated slag from metal smelting processes. As copper slags are known to be waste material and cause a lot of environmental problems, it would be a good idea to use them in different sections of industry such as pavement construction. On the other hand, in order to save energy and reduce the amount of pollutants re...
متن کاملThe Compressive Strength of Cement–Slag–Calcium Sulphoaluminate Ternary System
At present, there is an increasing interest on the use of calcium sulphoaluminate (C4A3$) in cement. In this paper, pure mineral of sulphoaluminate (C4A3$) was prepared in laboratory. Different dosages of steel slag and C4A3$ were blended into cement. The aim of this paper is to investigate the compressive strength of this ternary system. The test results show that the addition of C4A3$ can imp...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Mining and Metallurgical Institute of Japan
سال: 1983
ISSN: 0369-4194,2185-6729
DOI: 10.2473/shigentosozai1953.99.1139_43