Slag Behavior in Gasifiers. Part II: Constitutive Modeling of Slag

Slag Behavior in Gasifiers. Part II: Constitutive Modeling of Slag

The viscosity of slag and the thermal conductivity of ash deposits are among two of the most important constitutive parameters that need to be studied. The accurate formulation or representations of the (transport) properties of coal present a special challenge of modeling efforts in computational fluid dynamics applications. Studies have indicated that slag viscosity must be within a certain r...

Slag Behavior in Gasifiers. Part I: Influence of Coal Properties and Gasification Conditions

In the entrained-flow gasifiers used in integrated gasification combined cycle (IGCC) plants, the majority of mineral matter transforms to liquid slag on the wall of the gasifier and flows out the bottom. However, a small fraction of the mineral matter is entrained (as fly ash) with the raw syngas out of the gasifier to downstream processing. This molten/sticky fly ash could cause fouling of th...

The Effect of Slag Modeling to Improve Steelmaking Processes

This paper attempts to illustrate the benefits of using slag models based on the thermodynamics of steelmaking reactions and the multi-dimensional modeling of phase equilibria. The use of mass balance calculations and the application of these personal computer-based slag models to the refinement of standard operating procedures can simultaneously result in shorter process times, more predictabl...

Slag Hydration in composite cements

Despite reported synergies between alumina rich supplementary cementitious materials (SCMs) and limestone, previous studies have focused on up to 5% limestone content. Slag hydration in the presence of 10% limestone is reported in this paper. Hydration was followed through chemical shrinkage, calorimetry, thermal analysis, electron microscopy and X-ray powder diffraction. The results show that ...

The Estimation of Slag Properties