Sintering behavior of Y2O3 doped Bi2O3 ceramics
نویسندگان
چکیده
منابع مشابه
Sintering Behavior of 0.8 mol%-CuO-Doped 3Y-TZP Ceramics
In recent years, 3 mol% yttria-stabilized tetragonal zirconia polycrystals (3Y-TZP) doped with copper oxide has obtained increasing interest due to its enhanced superplastisity and good potential in tribological applications. In this work, the effect of addition of small amounts (0.8 mol%) of copper oxide on the sintering behavior of 3Y-TZP was studied using a dilatometer and high-temperature X...
متن کاملEffect of Microwave Sintering on the Microstructure and Dielectric Properties of Bi2O3-Doped (Ba0.6Sr0.4)(Ti0.94Cu0.06)O3 Ceramics
The effects of microwave sintering on the sintering behaviour, microstructure and dielectric properties of Bi2O3doped (Ba0.6Sr0.4)(Ti0.94Cu0.06)O3 (BSTC) ceramics were investigated. The microstructure and dielectric properties of a BSTC ceramic were also studied given different amounts of Bi2O3 doping. Microwave heating with sintering temperatures below 1000 ̊C significantly improves the densifi...
متن کاملLow-temperature sintering of MnO2-doped PZT–PZN Piezoelectric ceramics
The effect of MnO2 addition on the microstructural evolution and piezoelectric properties of low temperature sinterable PZT–PZN ceramics was investigated. When a small amount of MnO2 (≤0.5 wt% ) was added, the Mn ions were homogeneously dissolved in the PZT– PZN ceramics, leading to full densification at a temperature as low as 930 °C. However, the further addition of MnO2 hindered the densific...
متن کاملSintering of Ceramics
Sintering with low frequency rf power (-50 M H z ) is a new technique with unique capabilities that has been used to sinter a variety of ceramic materials, including zirconia-toughened alumina, alumina, silicon carbide, and boron carbide. Processing with low frequencies offers many advantages compared to processing with conventional microwave frequencies (915 MHz and 2.45 GHz). Because of the l...
متن کاملSintering Behavior and Properties of Iron-Rich Glass-Ceramics
Iron-rich glass-ceramics were obtained by the sintering of two glass powders, labeled G1 and G2, at heating rates of 5° and 20°C/min followed by an isothermal step in the 850°–1050°C temperature interval. The sintering process was evaluated by the linear shrinkage; the closed porosity was estimated by density measurements; the structure and the morphology of the glass ceramics were observed by ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science of Sintering
سال: 2007
ISSN: 0350-820X,1820-7413
DOI: 10.2298/sos0703215a