Sintering Behavior of Fly ash/NiCr Functionally Graded Materials Prepared by Spark Plasma Sintering (SPS)
نویسندگان
چکیده
منابع مشابه
Fabrication and Characteristics of 8YSZ/Ni functionally Graded Materials by Applying Spark Plasma Sintering Procedure (RESEARCH NOTE)
Functionally graded materials (FGM) in the form of layered structure consisting of yttria stabilized zirconia (8 mol% Y2O3) and nickel were fabricated by spark plasma sintering procedure. The relative density, linear shrinkage and Vickers hardness of each layer of graded materials were measured. The microstructure and the composition of these components were studied. The results obtained show t...
متن کاملSpark Plasma Synthesis (SPS) Device for Sintering of Nanomaterials
It is known that work pieces with nanocrystalline structure condition have much higher performance than those with an ordinary structure. There are known number of techniques for manufacturing of nanocrystalline materials in powder condition however a question of manufacturing bulk pieces in the same nanocrystalline state mentioned is that compaction and synthesizing of nanocrystalline powders ...
متن کاملSpark-plasma-sintering (SPS) of nanostructured titanium carbonitride powders
Spark-Plasma-Sintering (SPS) compaction experiments of nanostructured titanium carbonitride powders have been performed at 1600°C and 1800°C (sintering time = 1 min). The as-received nanostructured samples have been synthesized by rapid condensation from the gas-phase (high frequency plasma). The sintering results were compared with data obtained by various conventional sintering techniques suc...
متن کاملEffect of Nano-TiN on Mechanical Behavior of Si3N4 Based Nanocomposites by Spark Plasma Sintering (SPS)
متن کامل
Application of Spark Plasma Sintering for Manufacturing of Thermoelectric Materials
V-VI thermoelectric compounds like Bi2Te3-based alloys are well known for room temperature applications like Peltier coolers or thermogenerators. Their anisotropic physical properties and mechanical weakness are a problem for the manufacturing. To overcome the mechanical problem Spark Plasma Sintering (SPS) was used. 2 inch Wafers of polycrystalline bismuth telluride based n-type and p-type the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 2010
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.57.333