Sintered High Carbon Wear Resistant Material for Side Seal of Rotary Engine.
نویسندگان
چکیده
منابع مشابه
Sintered hydroxyapatite ceramic for wear studies.
A sintered hydroxyapatite (HAP) ceramic for use in wear studies was prepared from a commercial tricalcium phosphate. The sintered HAP had physical properties close to those of human enamel. The coefficient of friction and wear of the sintered HAP ceramic as characterized by tangential force, track width, and surface failure data, approximated those of human enamel.
متن کاملApex Seals for a MEMS Rotary Engine
This paper presents possible solutions to the problem of leakage in the MEMS rotary engine currently being developed at U.C. Berkeley. The project is motivated by the challenge to develop a system capable of a higher specific energy than primary batteries. Currently, leakage is the limiting factor in obtaining an engine with an acceptable efficiency. Fluidic analysis has been done to determine ...
متن کاملMaterial Flow in Rotary Drums
The experimental investigation of material flow in rotary drums is studied. An equipment in the size of pilot-scale was used to collect experimental data for investigation of validity of the conventional steady-state model of material flow in rotary drums. Also, the transient data of the time required for material movement in the empty drum up to any specified cross section are also reported. T...
متن کاملSintered material from alkaline basaltic tuffs
he possibility to obtain sintered material from alkaline basaltic tuffs is demonstrated. The parent rock was milled for 10–15 min, the resulting owder was pressed at 100 MPa and the obtained samples were heat-treated in the range of 1000–1140 ◦C. The sintering behaviour and the phase ormation were studied by pycnometry, dilatometry, DTA, XRD and SEM. The final material was obtained by sintering...
متن کاملA Study of the Wear Behavior of a Rail Material
The rail track is one of the most important elements of a railway system. During the passage of trains, the rails are subjected to contact load that comes from the wheels of the train. The railway track often fails in service due to wear caused by contact fatigue and other wear damage mechanisms that could also limit the life span of the railway infrastructure and railway vehicle. The aim of t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 2003
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.50.79