منابع مشابه
Asbestos exposure during routine brake lining manufacture.
Occupational exposure to asbestos fiber and total dust of workers of a major brake lining manufacture plant in a developing country were examined and compared with those in developed countries. Time weighted average of total dust and asbestos fiber concentration in the potential sources of exposure were monitored. All personal air sampling were collected on membrane filters and analyzed by phas...
متن کاملAn Investigation Toward Development Of Economical Brake Lining Wear Alert System
Brakes and tires are the major contributors for catastrophic failure of ground vehicles. Braking system is the utmost important besides tire to ensure the safety of users and vehicle. Ensuring good condition of brake lining is very crucial to ensure the efficiency of the braking system, where, the worn off brake lining not only endangers life but also damages the entire brake associated parts s...
متن کاملSolidification and Stabilization of Asbestos Brake Lining Dust Using Polymeric Resins
Two polymeric resins, Polymal and Hetron, were evaluated to solidify/stabilize (S/S) for ultimate disposal brake lining dust containing asbestos. This dust was generated as part of a sequence of processing steps in the manufacture of automobile brake linings. The mean grain size of the lining dust for disposal was 298.2 m m, the range being from 24.9 to 567.3 m m. Based on the Toxicity Characte...
متن کاملAsbestos bodies in bronchoalveolar lavage fluids of brake lining and asbestos cement workers.
Asbestos body (AB) concentrations in bronchoalveolar lavage samples of 15 brake lining (BL) workers exposed only to chrysotile have been determined and compared with those from 44 asbestos cement (AC) workers extensively exposed to amphiboles. The mean AB concentrations (263 +/- 802 and 842 +/- 2086 AB/ml respectively) for those groups did not differ significantly but were much higher than thos...
متن کاملinvestigation of possibility of using lignocellulosic materials and nano alominum oxide in manufacture of brake lining
in the present study, development of new asbestos-free brake pad using lingo-cellulosic fibers and nano aluminum oxide particles was investigated. variable factors were the type of lignocellulosic materials (jute, bagass and rice husk) and the size of aluminum particles (nano and micron). these newly formulated brake pads have been tested under the grey cast iron disc. friction coefficient and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1967
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.14.203