منابع مشابه
Investigation of crystallization and sinterability properties of BaO-Al2O3-SiO2 glass-ceramics containing K2O and B2O3
BaO -SiO2-Al2O3 glass ceramics containing K2O and B2O3 were prepared using conventional melting of powered batches, quenching in water and crystallization of sintered glass. XRD patterns introducehexacelsian and celsian as two major crystallized phases in sintered glass-ceramics. Presence of K2O enhances crystallization of hexacelsianin comparison withB2O3.Observations showed sintering temperat...
متن کاملCRYSTALLIZATION AND SINTERABILITY BEHAVIOR OF BIORESORBABLE CaO-P2O5-Na2O-TiO2 GLASS CERAMICS FOR BONE REGENERATION APPLICATION
Abstract:Some types of glass and glass ceramics have a great potential for making bone tissue engineering scaffolds, drug carrier and bone cements as they can bond to host bone, stimulate bone cells toward osteogenesis, and resorb at the same time as the bone is repaired. Calcium phosphate glass ceramics have very attractive properties that allow them to use in bone tissue engineering. Calcium ...
متن کاملImproving NASICON Sinterability through Crystallization under High-Frequency Electrical Fields
The effect of high-frequency (HF) electric fields on the crystallization and sintering rates of a lithium aluminum germanium phosphate (LAGP) ion conducting ceramic was investigated. LAGP with the nominal composition Li1.5Al0.5Ge1.5(PO4)3 was crystallized and sintered, both conventionally and under effect of electrical field. Electrical field application, of 300 V/cm at 1 MHz, produced up to a ...
متن کاملB4C-Al Composites Fabricated by the Powder Metallurgy Process
Due to the large thermal neutron absorption cross section of 10B, B4C-Al composites have been used as neutron absorbing materials in nuclear industries, which can offer not only good neutron shielding performance but also excellent mechanical properties. The distribution of B4C particles affects the mechanical performance and efficiency of the thermal neutron absorption of the composite materia...
متن کاملHardness and friction of N: and Al+ implanted B4C
Surfaces of boron carbide (B4C) were implanted with 200 keV N: or 100 keV AI + ions to a dose of 8 x 10” cm‘. Ultralow load indentation via the Nanoindenter was used to determine the changes in surface hardness and elastic modulus following implantation. A pin-on-disk testing device in ultrahigh vacuum was used for measuring changes in friction and wear of the implanted disks. Results of hardne...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Advanced Science
سال: 2000
ISSN: 1881-3917,0915-5651
DOI: 10.2978/jsas.12.79