Single-step Preparation of Nano-homogeneous NiO/YSZ Composite Anode for Solid Oxide Fuel Cells
نویسندگان
چکیده
منابع مشابه
Importance of Anode Microstructure in Modeling Solid Oxide Fuel Cells
A one-dimensional button-cell model is developed and applied to explore the influence of anode microstructure on solid oxide fuel cell (SOFC) performance. The model couples porous-media gas transport and elementary electrochemical kinetics within a porous Ni-YSZ cermet anode, a dense YSZ electrolyte membrane and a composite LSM-YSZ cathode. In all cases the fuel is humidified H2 and air is the ...
متن کاملPore Former Addition in the Preparation of Highly Porous Anode Using Phase-inversion Technique for Solid Oxide Fuel Cell
A detailed study on the anode structure of solid oxide fuel cell (SOFC) is very crucial in developing high performance power generating devices, given how porous electrodes are known to provide a number of active sites for reaction, consequently accelerate fuel conversion. This present study investigates the feasibility of pore former addition to nickel oxideyttria stabilized zirconia (NiO-YSZ)...
متن کاملNanostructuring Platinum Nanoparticles on Ni/Ce0.8Gd0.2O2-δ Anode for Low Temperature Solid Oxide Fuel Cell via Single-step Infiltration: A Case Study
With the aim of promoting the Ni/Ce0.8Gd0.2O2-δ (Ni/GDC20) cermet anodic performance of low temperature solid oxide fuel cell (LT-SOFC) [1], nanostructuring platinum nanoparticles on NiO/GDC composite was done by single-step wet-infiltration of hexachloroplatinic acid hexahydrate (H2PtCl6.6H2O) precursor on NiO/GDC20 composite. The anodic polarization resistance was measured using symmetr...
متن کاملPreparation of Ni-ysz Nano-fiber Composite as Fuel Cell Anode Material
A novel route to fabricate nano-fiber anode material for solid oxide fuel cells (SOFCs) is presented. Firstly, uniform nano-fibers of 8 mol % Yttria Stabilized Zirconia (8YSZ) were formed in an electrospinning process; then, these electrospun fibers were calcined at temperatures up to 1300 °C; and finally the ceramic 8YSZ nano-fibers were coated with nickel in an electroless plating process. Th...
متن کاملCeramic - Based Anode for Solid - Oxide Fuel Cell Utilizes
490 MRS BULLETIN/JULY 2002 nated by intergranular fracture, while in AJM it was in a manner resembling ductile behavior. Improved surface finishing by AJM resulted in a 15% improvement in flexural strength, compared with both ground and ground-plus-lapped samples. The researchers concluded that a higher compressive residual stress observed on the AJM-processed surface, combined with the smoothe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nano-Micro Letters
سال: 2013
ISSN: 2150-5551
DOI: 10.5101/nml.v5i2.p111-116