Single-layer bandpass active frequency selective surface
نویسندگان
چکیده
منابع مشابه
Single-Layer Bandpass Active Frequency Selective Surface
A single-layer, bandpass, active FSS is presented. It shows good angle of incidence stability for TE incidence, at the operating frequency of 2.45 GHz. It is based on circular loop aperture with each unit cell having four PIN diodes. A novel method for dc biasing is used. About 12 dB average variation in transmission loss, between ON and OFF states, has been experimentally achieved at 2.45 GHz.
متن کاملSingle - Layer Bandpass Active Frequency Selective Surface
If you believe this document infringes copyright then please contact the KAR admin team with the take-down information provided at http://kar.kent.ac.uk/contact.html Citation for published version Ghaffer, I Kiani. and Ford, Kenneth L. and Esselle, Karu P. and Weily, Andrew R. and Panagamuwa, C. and Batchelor, John C. (2008) Single-Layer Bandpass Active Frequency Selective Surface. Microwave an...
متن کاملPolarization Independent Triple-Band Single Layer Frequency Selective Structure
This paper deals with single layer polarization independent Frequency selective surface (FSS) which acts as a triple band reject filter. The two stop bands are broad with percentage bandwidth 11.16% and 10.13% and one is narrow with 3.33% bandwidth. The band ratio is more than 1.5 and band separation is around 30-35dB. This design is investigated theoretically by ANSOFT® Designer software and p...
متن کاملFrequency-selective Surface Based Bandpass Filters in the Near-infrared Region
A spatial bandpass filter resonant at 1.5 m and based on a frequency-selective surface (FSS) was analyzed and fabricated. It consists of circular apertures arranged in a hexagonal lattice and was modeled using a hybrid finite-element/boundary-integral method, which accounted for metal thickness and conductivity. Measurements demonstrate the accuracy of the design. © 2004 Wiley Periodicals, Inc....
متن کاملEquivalent Circuit Model for Square Ring Slot Frequency Selective Surface
An equivalent circuit model for predicting the frequency response of a square ring slot frequency selective surface (SRS-FSS) for normal incidence is described. The proposed FSS consists of an array of square patches centered within a wire grid. The presented circuit model is formed by the impedance of the wire grid that is parallel with the impedance of the patch array, also the mutual couplin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Microwave and Optical Technology Letters
سال: 2008
ISSN: 0895-2477,1098-2760
DOI: 10.1002/mop.23615