Single Lap Joints Numerical Modelling and Comparison with Experimental Testing
نویسندگان
چکیده
منابع مشابه
Simulation Analysis and Nondestructive Testing of Flexural Performance of Wood Single Lap Glued Joints
The effect of joint size on the loading capacity of wood single lap joints was studied with an orthogonal experimental design. The maximum load, modulus of elasticity, and modulus of rupture were the three mechanical indexes used to evaluate wood joint quality. A simulation model of bending tests was established using the finite element method. The stress distributions of the joints were analyz...
متن کامل3-D Experimental and FEA Investigations of Thick Single-lap Bolted Joints
Stresses in single-lap bolted joints of thick plates are complex and difficult to analyze. The few previous studies of stress through the thickness of bolted joints have been limited to finite element simulations and have been implemented only for the joining of relatively thin plates. Experimental and numerical analyses were conducted to analyze the stress distribution inside thick bolted plat...
متن کاملExperimental and Analytical Investigations of the Dynamic Response of Adhesively Bonded Single Lap Joints
Dynamic response of single lap joints, subjected to a harmonic peeling load is studied theoretically and experimentally. In the theoretical part, dynamic response of a single lap joint clamped at one end and subjected to a harmonic peeling load at the other end is investigated. Adherents are modeled as Euler-Bernouli beams joined in the lap area by a viscoelastic adhesive layer. Both axial and ...
متن کاملFailure Mode Analysis of Aluminium Alloy 2024-T3 in Double-Lap Bolted Joints with Single and Double Fasteners; A Numerical and Experimental Study
This paper aims to study the mechanical behaviour and failure mode of Al 2024-T3 in double-lap bolted joints. To accomplish this, the effect of geometric parameters was investigated in both configurations of single and double fasteners. Using ABAQUS/Standard, a three-dimensional finite element model was developed and verified against the experimental results of the joints loaded in tension. In ...
متن کاملAdvances in Numerical Modelling of Adhesive Joints
The analysis of adhesively bonded joints started in 1938 with the closed-form model of Volkersen. The equilibrium equation of a single lap joint led to a simple governing differential equation with a simple algebraic equation. However, if there is yielding of the adhesive and/or the adherends and substantial peeling is present, a more complex model is necessary. The more complete is an analysis...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: U.Porto Journal of Engineering
سال: 2018
ISSN: 2183-6493
DOI: 10.24840/2183-6493_002.001_0002