Single and Multiple Circumferential Casing Groove for Stall Margin Improvement in a Transonic Axial Compressor

نویسندگان

چکیده

Abstract The stability limit of a tip-stalling axial compressor is sensitive to the magnitude near-casing blockage. In transonic compressors, presence passage shock could be major cause for Identification and elimination this blockage key improving compressor. article, using numerical simulation, within rotor, NASA Rotor 37, quantified parameter. For smooth casing, at conditions near stall maximum about 20% tip chord downstream leading edge. This location found consistent with shock–tip leakage vortex interaction. A datum single casing groove design that minimizes peak through an optimization approach. margin improvement 0.6% negligible efficiency penalty. Furthermore, varied upstream location. It shown best improved when reduced article also discusses prospects multigroove configuration.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Numerical Investigation for the Impact of Single Groove on the Stall Margin Improvement and the Unsteadiness of Tip Leakage Flow in a Counter-Rotating Axial Flow Compressor

A low-speed counter-rotating axial flow compressor (CRAC) with single circumferential grooved casing treatment (CT) was investigated numerically. Both steady and time-accurate numerical calculations were performed to study the effects of the single grooved CTs over the rear rotor on the stability enhancement and the unsteadiness of tip leakage flow (TLF) in the CRAC. Parametric studies indicate...

متن کامل

Numerical study of the effect of the tip gap size and using a single circumferential groove on the performance of a multistage compressor

The effect of the tip gap size on the performance of a multistage axial compressor was studied by means of computational fluid dynamics (CFD). It was found that the performance of the compressor was very sensitive to the size of the tip gap. By increasing the gap size, the stall margin value, the total pressure ratio and the compressor efficiency reduced considerably. The flow field at the tip ...

متن کامل

Numerical Investigation of Rotating-Stall in a Stage of an Axial Compressor with Two Different Approaches

An unsteady two-dimensional finite-volume solver was developed based on Van Leer’s flux splitting algorithm in conjunction with “Monotonic Upstream Scheme for Conservation Laws (MUSCL)” limiters and the two-layer Baldwin-Lomax turbulence model was also implemented. To validate the solver, two test cases were prepared and the computed results had good agreements with reference data. The rotating...

متن کامل

Unsteady Transonic Flows in an Axial Flow Compressor*

Introduction. This paper deals with some transonic flow problems for the supersonic axial flow compressor: these arise in connection with flutter analysis for fan blading. Very detailed solutions for unsteady plane transonic flows through a cascade of flat plates have been given by Goldstein Braun and Adamczyk (1977) and Nagashima and Whitehead (1977), see also Goldstein (1975), Kurosaka (1974)...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of turbomachinery

سال: 2021

ISSN: ['0889-504X', '1528-8900']

DOI: https://doi.org/10.1115/1.4050444