Simultaneous Removal of Al, Cu and Zn Ions from Aqueous Solutions Using Ion and Precipitate Flotation Methods

نویسندگان

چکیده

This paper presents the results of investigations concerning simultaneous removal Al(III), Cu(II), and Zn(II) from dilute aqueous solutions using ion precipitate flotation methods. The effects initial solution pH, surface active substance concentration, gas velocity on flotations’ efficiency course are studied. Experimental discussed in terms physicochemical aspects related to metal salts. indicate that satisfying flotations aluminum, copper zinc species observed if pH value ranges between 7.0 9.0. It was found an increase collector concentration a decrease rate constants. An rates.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Removal of Pb(II) and Cu(II) Ions from ‎Aqueous Solutions by Cadmium Sulfide ‎Nanoparticles

   In this study, cadmium sulfide nanoparticles (CdS NPs) were prepared, characterized and used as a new adsorbent for simultaneous removal of Pb(II) and Cu(II) ions from aqueous solutions. Using a batch adsorption method, the effects of solution pH, contact time, adsorbent dose, and temperature were studied and optimized. Removal efficiencies, higher than 98% were obtained for both the met...

متن کامل

Removal of Lead Ions from Aqueous Solution by Sorptive-Flotation Using Limestone and Oleic Acid

A simple, rapid and economic procedure was presented to remove lead(II) from aqueous solution under the optimized conditions. It is based on the sorption of Pb2+ ions from aqueous solutions onto limestone fines (LS), which is an inexpensive and widespread over the globe, followed by flotation with oleic acid (HOL) surfactant. The different parameters (namely: solution pH, sorbent...

متن کامل

Removal of copper ions from aqueous solutions using polypyrrole and its nanocomposites

In this article, preparation of polypyrrole and its nanocomposites as adsorbents werediscussed and the capability of separation of copper ions from aqueous solution were studied.Polypyrrole was prepared by chemical oxidative polymerization method of pyrrole usingFeCl3 as an oxidant. The removal of Cu (II) was investigated using PPy, PPy/TiO2 andPPy/TiO2/DHSNa nanocomposites. The products were i...

متن کامل

Removal of Hg (I) and Hg (II) Ions from Aqueous Solutions, Using TiO2 Nanoparticles

For the first time, the present study removes ions of mercury, in the form of Hg (I) and Hg (II) ions, from aqueous solutions by adsorbing them onto titanium dioxide nanoparticles. The effects of various parameters, such as solution's initial pH, temperature, sorbent dosage, initial mercury concentration, and contact time have been examined on the adsorption process. The experimental results ha...

متن کامل

Removal of thiocyanate ions from aqueous solutions using polypyrrole and polyaniline conducting electroactive polymers

Polypyrrole (PPy/Cl) and polyaniline (PAni/Cl) synthesized chemically onto sawdust (SD)was used for removal of thiocyanate (SCN-) ions from aqueous solutions. The effect of someimportant parameters such as pH, initial concentration, sorbent dosage, and contact time onuptake of SCN- was investigated. PPy/SD was found to be much more effective sorbent thanPAni/SD for uptake SCN- from aqueous solu...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Processes

سال: 2021

ISSN: ['2227-9717']

DOI: https://doi.org/10.3390/pr9020301