Simultaneous measurement of target distance and azimuth in four quadrant detection
نویسندگان
چکیده
منابع مشابه
investigation of single-user and multi-user detection methods in mc-cdma systems and comparison of their performances
در این پایان نامه به بررسی روش های آشکارسازی در سیستم های mc-cdma می پردازیم. با توجه به ماهیت آشکارسازی در این سیستم ها، تکنیک های آشکارسازی را می توان به دو دسته ی اصلی تقسیم نمود: آشکارسازی سیگنال ارسالی یک کاربر مطلوب بدون در نظر گرفتن اطلاعاتی در مورد سایر کاربران تداخل کننده که از آن ها به عنوان آشکارساز های تک کاربره یاد می شود و همچنین آشکارسازی سیگنال ارسالی همه ی کاربران فعال موجود در...
A Four-Quadrant PVDF Transducer for Surface Acoustic Wave Detection
In this paper, a polyvinylidene fluoride (PVDF) piezoelectric transducer was developed to detect laser-induced surface acoustic waves in a SiO(2)-thin film-Si-substrate structure. In order to solve the problems related to, firstly, the position of the probe, and secondly, the fact that signals at different points cannot be detected simultaneously during the detection process, a four-quadrant su...
متن کاملFour quadrant FGMOS analog multiplier
A novel four-quadrant analog multiplier using floating gate MOS (FGMOS) transistors operating in the saturation region is presented. The drain current is proportional to the square of the weighted sum of the input signals. This square law characteristic of the FGMOS transistor is used to implement the quarter square identity by utilizing only six FGMOS transistors. The main features of this rem...
متن کامل±1.5V CMOS Four-Quadrant Multiplier
− A low-voltage CMOS four-quadrant analogue multiplier using two NMOS operated in the triode region with modified bi-directional regulated cascade (RGC) structure is presented. The circuit can operate from a supply voltage of ±1.5V. For a differential input voltage range up to ±0.8V, this circuit has kept nonlinearity below 0.9% and total harmonic distortion less than 1%. The −3dB bandwidth of ...
متن کاملSimultaneous Measurement of Tempearture and Strain Using Four Connecting Wires
This paper describes a new signal-conditioning technique for measuring strain and temperature which uses fewer connecting wires than conventional techniques. Simultaneous measurement of temperature and strain has been achieved by using thermocouple wire to connect strain gages to signal conditioning. This signal conditioning uses a new method for demultiplexing sampled analog signals and the An...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2020
ISSN: 1742-6588,1742-6596
DOI: 10.1088/1742-6596/1633/1/012127