Simulator for beam-based LHC collimator alignment

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Remote Control of Heterogeneous Sensors for 3d Lhc Collimator Alignment

Periodically the alignment of LHC collimators needs to be verified. Access for personnel is limited due to the level of radiation close to the collimators. The required measurement precision must be comparable to the other equipment in the LHC tunnel, meaning 0.15 mm in a sliding window of 200 m. Hence conventional measurements take 4 days for a team of 3 people. This presentation covers the de...

متن کامل

Optimization of Collimator Jaw Locations for the LHC

A highly effective collimation scheme is required in the LHC to limit heating of the vacuum chamber and superconducting magnets by protons either uncaptured at injection or scattered by non-linear phenomena. The proposed system would consist of one set of primary collimators followed by three sets of secondary collimators downstream to clean up protons scattered from the primaries. Each set of ...

متن کامل

Ultimate Lhc Beam

The present status of the nominal LHC beam in the LHC injector complex and the limitations towards the achievement of the ultimate brightness are outlined.

متن کامل

Automatic Computer Algorithms for Beam-based Setup of the Lhc Collimators∗

Beam-based setup of the LHC collimators is necessary to establish the beam centers and beam sizes at the collimator locations and determine the operational settings during various stages of the LHC machine cycle. Automatic software algorithms have been successful in reducing the costly beam time required for the alignment, as well as significantly reducing human error. In this paper, the beam-b...

متن کامل

Lhc Beam Instrumentation

Six years before the scheduled commissioning of the LHC at CERN, the basic list of beam instruments has been established. This early date is needed due to the impact of the mechanical design of some detectors (mainly the beam position detectors) on the cryogenic part of the machine as well as for other projects due to the long R&D period (emittance measurements, tune and chromaticity diagnostic...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Physical Review Special Topics - Accelerators and Beams

سال: 2014

ISSN: 1098-4402

DOI: 10.1103/physrevstab.17.021003