Simulative basic investigation for a new forming process punch-hole-rolling
نویسندگان
چکیده
منابع مشابه
analytical investigation of rupture phenomena in sheet hydro-forming process by hemispherical punch
rupture and wrinkling are two prevalent phenomena that happen in hydro-forming process. many efforts have been made to achieve the upper and lower bounds for the pressure related to rupture and wrinkling of sheet, respectively. the aim of this investigation is to improve the upper bound of fluid pressure in hydro-forming process by hemispherical punch. in this article, analytical study of the u...
متن کاملDevelopment of a Predictive Finite Element Model For Investigation of Phases Behavior After Cold Rolling Process
One of the surface defects that arise in sheet metal working is when the part removes from the die. Since there are no external forces to make this defect, the origin of such fail is known as residual stress. Residual stress can develop in sheet metal forming due to non uniform deformation. In this paper, the workpiece is carbon steel with different volume fractions and arrangement of ferrite ...
متن کاملInvestigation into a new incremental forming process using an adjustable punch set for the manufacture of a doubly curved sheet metal
For ̄ exible manufacture of a doubly curved sheet metal, a new sheet metal forming process is proposed that uses a movable punch set composed of two pairs of lower support punches and one upper centre punch. The process is characterized by ̄ exibility compared with the existing conventional processes because it does not require any complex-shaped die and the loss of material is minimized by unc...
متن کاملThe Effects of Forming Parameters on Conical Ring Rolling Process
The plastic penetration condition and biting-in condition of a radial conical ring rolling process with a closed die structure on the top and bottom of driven roll, simplified as RCRRCDS, were established. The reasonable value range of mandrel feed rate in rolling process was deduced. A coupled thermomechanical 3D FE model of RCRRCDS process was established. The changing laws of equivalent plas...
متن کاملFem Analysis of Hollow Hub Forming in Rolling Extrusion Process
J. Bartnicki, Lublin University of Technology, Lublin, Poland In this paper are presented the results of numerical calculations of rolling extrusion process of a hollow hub. As the flanges manufacturing at both sides of the product is required, in the analyzed process of rolling extrusion, a rear bumper was implemented as additional tool limiting axial metal flow. Numerical calculations of the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Manufacturing
سال: 2020
ISSN: 2351-9789
DOI: 10.1016/j.promfg.2020.08.091