Simulation Technology of Microcellular Injection Molding by using True 3 D Plastic Flow Analysis “Moldex 3 D”

Investigation of 3-D Flow in a Chamber

3-D Numerical Simulation of Gas Turbine Combustor

This paper presents a numerical solution for a changing combustor geometry. The effects of the geometric change on the main parameters of the chamber are considered. For this purpose the original geometry and the new one are simulated numerically by a 3-D CFD code and the results are compared. Finally, comments are presented regarding this change. A model is used for turbulence modeling and a...

3-D Numerical Simulation of Gas Turbine Combustor

This paper presents a numerical solution for a changing combustor geometry. The effects of the geometric change on the main parameters of the chamber are considered. For this purpose the original geometry and the new one are simulated numerically by a 3-D CFD code and the results are compared. Finally, comments are presented regarding this change. A model is used for turbulence modeling and a...

Investigation of 3-D Flow in a Chamber

3-D ICs: Performance Analysis, and Technology

Interconnect delays are increasingly dominating IC performance due to increases in chip size and reduction in the minimum feature size [1]. In spite of new materials like Cu and a low-k dielectric interconnect delay is expected to be substantial below 130 nm technology node, thereby severely limiting chip performance [2]. Therefore, the need exists for alternative technologies to overcome this ...