Simulation of workpiece surface roughness after flat grinding by electroplated wheel
نویسندگان
چکیده
منابع مشابه
Study on Experimental and Modeling of Rotary Roll Dressing of Grinding Wheels
Two of the important parameters in grinding operation are surface roughness of the workpiece and the amount of consumed energy. These parameters are strongly affected by the condition of grinding wheel surface which is dependent on the dressing parameters. Predicting the roughness of the grinding wheel surface after dressing with known dressing parameters can improve the grinding process. Resea...
متن کاملA revisit to some wheel–workpiece interaction problems in surface grinding
This paper revisited some wheel–workpiece interaction problems in surface grinding including the profile of heat flux and the variation of the wheel’s elastic modulus. A method of using an optical microscope and a CCD camera was applied to capture the depth and width of the heated zone, the details of the temperature field and the stability of the heat flux. It was found that the heat flux in u...
متن کاملMathematical Modeling of Surface Roughness in Surface Grinding Operation
A mathematical model of the surface roughness has been developed by using response surface methodology (RSM) in grinding of AISI D2 cold work tool steels. Analysis of variance (ANOVA) was used to check the validity of the model. Low and high value for work speed and feed rate are decided from design of experiment. The influences of all machining parameters on surface roughness have been analyze...
متن کاملExperimental Investigation of the Surface Roughness in Grinding of BK7 Optical Glass in Brittle Mode
Surface roughness is a significant parameter which determines the efficiency of optical components. Surface damages induced by grinding strongly influence the mechanical strength and optical quality of optical glasses. It is meaningful to rapid evaluate the surface roughness through the measurement of different grinding parameters. In this study, a cup diamond wheel (D64) is used in grinding pr...
متن کاملFundamental Study on Cross Axis Grinding Method
In this study, it is experimentally investigated that the surface generation process in the cross axis grinding method with small diameter grinding wheel. In this grinding method, workpiece surface speed and sum of both wheel working surface speed and wheel feed rate crossed each other. Therefore, it is the largest characteristic that the cross angle, which is defined as the angle between the w...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2018
ISSN: 2212-8271
DOI: 10.1016/j.procir.2018.09.021