Simulation of cutting forces for complex surfaces in ball-end milling
نویسندگان
چکیده
منابع مشابه
An Instantaneous Rigid Force Model For 3-Axis Ball-End Milling Of Sculptured Surfaces
An instantaneous rigid force model for prediction of cutting forces in ball-end milling of sculptured surfaces is presented in this paper. A commercially available geometric engine is used to represent the cutting edge, cutter and updated part geometries. The cutter used in this work is an insert type ball-end mill. Intersecting an inclined plane with the cutter ball nose generates the cutting...
متن کاملModeling of three-dimensional cutting forces in micro-end-milling
A new nominal uncut chip thickness algorithm for micro-scale end-milling is proposed by considering the combination of an exact trochoidal trajectory of the tool tip and tool run-out, and then the actual uncut chip thickness may be obtained from a comparison between the current accumulative uncut chip thickness and the minimum chip thickness. Due to the intermittency of the chip formation, the ...
متن کاملPrediction of Chatter in CNC Machining based on Dynamic Cutting Force for Ball End Milling
This paper presents the suitable depth of cut, spindle speed and feed rate that will be chosen during machining. If thus parameters are not considered, this can provoke abnormal tool behavior such as chatter. Chatter will limit the tool life which only can be use for just a few times. To predict the chatter occurs, the parameters will be use are spindle speed, depth of cut and feed rate. CNC ma...
متن کاملModelling and Numerical Simulation of Cutting Stress in End Milling of Titanium Alloy using Carbide Coated Tool
Based on the cutting force theory, the cutting stress in end milling operation was predicted satisfactorily through simulation of using finite element method. The mechanistic force models were introduced in high accuracy force predictions for most applications. The material properties in the simulations were defined based on the cutting force theory, as a function of strain and strain rate wher...
متن کاملCombined DEM and SPH simulation of ball milling
A deeper understanding of the milling operation of ball mills helps mineral processing engineers to control and optimize them, and therefore, reduce their consuming power. In this work, the milling operation of ball mills is investigated using two methods, i.e. DEM and combined DEM-SPH. First, a pilot scale ball mill with no lifter is simulated by both methods. Then another pilot scale ball mil...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Simulation Modelling
سال: 2008
ISSN: 1726-4529
DOI: 10.2507/ijsimm07(2)4.106