Simulation of CuE Copper Alloy in a Closed-Die Multi-Axial Forging Tool
نویسندگان
چکیده
Abstract Two-way multi-axial forging was performed on a newly designed closed-die tool. The tool operated an MTS 810 material testing system. connected computer recorded force and crosshead displacement as function of time during operation. sample the four-step experiment CuE copper alloy. plastic deformation 0.8 per step, thus rate cumulative equivalent strain 3.2 by end process. speed movement active tools whole test 2 mm/min. Finite element simulation with QForm3D software to investigate conditions necessary flow curve determined Watts-Ford test. force-displacement curves physical were compared results finite modeling.
منابع مشابه
Numerical Simulation of Hot Closed Die Forging of a Low Carbon Steel Coupled with Microstructure Evolution
Hot closed die forging is a regular process applied to manufacture metallic components used in supporting and fixing cable conductors in electric power transmission lines. In this forming process, the final microstructure of the workpiece depends on the control of several processing parameters. In this study, simulation of the industrial forging process of a ball hook component was performed us...
متن کاملOptimization of Flash, Billet Dimensions and Friction Factor in Closed Die Cold Forging Process
Three important parameters in designing a closed die for forging process are ratio of width to flash thickness, ratio of height to billet diameter and the friction factor. In this paper the influences of these parameters on the required force for the forging and percentage of die filling were investigated. It was found that by controlling the flash dimension, the material loss is reduced and t...
متن کاملGrain Refinement Efficiency of Multi-Axial Incremental Forging and Shearing: A Crystal Plasticity Analysis
Severe plastic deformation is a technical method to produce functional material with special properties such as high strength and specific physical properties. Selection of an efficient severe plastic deformation for grain refinement is a challenging field of study and using a modeling technique to predict the refinement efficiency has gained a lot of attentions. A comparative study was carried...
متن کاملDetermination of Load and Strain-Stress Distributions in Hot Closed Die Forging Using the Plasticine Modeling Technique
An axisymmetric hot closed die-forging process has been studied by physical modeling technique using the plasticine. To observe the material flow pattern, layers of plasticine with different colors were used. The normal direction to the layers was considered a principal direction. The strain distribution was obtained by measuring the thickness of the plasticine layers. Based on the strain distr...
متن کاملThe Simulation and Experimental Investigation to Study the Strain Distribution Pattern during the Closed Die Forging Process
Abstract—Closed die forging is a very complex process, and measurement of actual forces for real material is difficult and time consuming. Hence, the modelling technique has taken the advantage of carrying out the experimentation with the proper model material which needs lesser forces and relatively low temperature. The results of experiments on the model material then may be correlated with t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Materialia Transylvanica
سال: 2022
ISSN: ['2668-1366', '2601-1883']
DOI: https://doi.org/10.33924/amt-2022-01-01