Simulation of Cross Wedge Rolling and Hot Extrusion-Combined Forming Process for Axle Sleeve
نویسندگان
چکیده
In this paper, an axle sleeve is formed through a combined cross wedge rolling (CWR) and hot extrusion process, the forming process simulated via finite element analysis software Deform-3D. The mechanism revealed by analyzing stress strain distribution, temperature variation metal flow law of workpiece during CWR extrusion. Combined with experiments, feasibility to produce verified. It has been proven that outer steps produced composite are well formed, flange cavity full, streamline continuous, axis inner hole does not easily deviate, product quality good production efficiency high.
منابع مشابه
Fem Analysis of Hollow Hub Forming in Rolling Extrusion Process
J. Bartnicki, Lublin University of Technology, Lublin, Poland In this paper are presented the results of numerical calculations of rolling extrusion process of a hollow hub. As the flanges manufacturing at both sides of the product is required, in the analyzed process of rolling extrusion, a rear bumper was implemented as additional tool limiting axial metal flow. Numerical calculations of the ...
متن کاملSimulation System of Multistage Hot Rolling Process of Flat Products
The properties of each deformed product are decisively influenced by production process. By means of directed control of the various steps of process it is possible to obtain the desired properties. In order to reach this purpose and to estimate the properties of the end product the whole process chain must be presented as the whole set. This integrated approach starts with the solidified melt ...
متن کاملInvestigation and Simulation of Wire Non-Asymmetric Rolling Process
The non-asymmetric rolling process of copper and brass wire has been simulated with the Abaqus software. Presented finite element model in this simulation of rolling predicted output curvature and contact surface width in the non-asymmetric mode (in equality of diameter of rollers, the rotational speed of the rollers and the rollers’ surface finish). The material used in this research has strai...
متن کاملInvestigation of hot metal gas forming process of square parts
Aluminum alloys are considered a lot in the automotive and aerospace industry because of their high strength to weight ratio. In this manuscript, the gas forming process of aluminum AA6063 tubes at high temperatures up to 500°C is investigated, through experimental and numerical tests. Therefore, an experimental setup is prepared and so, tube specimens are formed in a die with square cross sect...
متن کاملsimulation and design of electronic processing circuit for restaurants e-procurement system
the poor orientation of the restaurants toward the information technology has yet many unsolved issues in regards to the customers. one of these problems which lead the appeal list of later, and have a negative impact on the prestige of the restaurant is the case when the later does not respond on time to the customers’ needs, and which causes their dissatisfaction. this issue is really sensiti...
15 صفحه اولذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metals
سال: 2023
ISSN: ['2075-4701']
DOI: https://doi.org/10.3390/met13061017