Simulation for forming process of interference fringe
نویسندگان
چکیده
منابع مشابه
Simulation of Orbital Forming Process
In this study the feasibility of 3D FEM simulation of the orbital forming process was investigated by evaluating the simulation time. Commercial FEA software DEFORM 3D v4.0 that has an efficient computation algorithm for simulating incremental forming process was used for the simulations and the savings in computation time was determined. In order to provide reliable flow stress for the simulat...
متن کاملSimulation Models of the Electromagnetic Forming Process
Suitable simulation approaches for the preliminary investigation of the electromagnetic metal forming process are presented. For this purpose an uncoupled (loose-coupled) simulation model is compared to a more rigorous sequential-coupled approach. As shown by examples, the connection between electromagnetic field and spatiotemporal evolution of the deformation of the workpiece cannot always be ...
متن کاملProcess Simulation for Optimizing Superplastic Forming of Sheet Metal
Superplastic forming (SPF) is conducted in a heated, pressurized die where direct monitoring of critical SPF parameters is extremely difficult. Numerical models provide a critical means of tracking the forming process, allowing the applied gas pressure to be adjusted to maintain optimum SPF behavior throughout the forming process. This paper describes how the MARC finite element code was used t...
متن کاملRobust Design Optimization in forming process simulation
Today, FE-simulation of forming process has become an integral part for assessing and evaluating forming processes. The optimization, i.e. improvement of product characteristics, has been an integral part of forming simulation based virtual product development for several years now. On the other hand, the robustness of forming processes is becoming more and more focused on recently. Therefore t...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Advanced Science
سال: 1998
ISSN: 1881-3917,0915-5651
DOI: 10.2978/jsas.10.2-3_138