Simulation and optimization of screw feeder in a bubbling fluidized bed gasification reactor
نویسندگان
چکیده
A fluidized bed biomass gasification reactor is used to produce syngas from and municipal wastes. Gasification a flexible technology where many different types of feedstocks can be used. The University South-Eastern Norway has 20kW which investigate the quality quantity produced using feedstocks. At present, challenge supply feedstock via transport screws. main consists achieving continuous feeding reduction in feed rate. Therefore, this work focused on optimization screw feeder obtain reduced rate while maintaining aim reduce approximately 8 kg/h 3-4 without missing continuity feeding.A model developed CAD software SolidWorks simulated open-source simulation LIGGGHTS combinations parameters. results are processed Excel viewed graphically with visualization ParaView. compared experimental measurements reactor. validated further parameters discussed.
منابع مشابه
Process simulation and sensitivity analysis of waste plastics gasification in a fluidized bed reactor
This paper presents a simplified process simulation model of typical waste polyethylene gasification in a fluidized bed reactor using Aspen Plus. The proposed model incorporates both physical and chemical processes, including drying, pyrolysis, combustion and gasification, by using various inbuilt modules to predict the resulting product gas composition and temperature. A detailed sensitivity a...
متن کاملBiomass Gasification in Fluidized Bed Gasifiers Modeling and Simulation
Using woody biomass as a resource for production of biofuel, heat and power through gasification has been studied for years. In order to reduce the cost of operating and to design the full-scale gasification plant developing a general model to be applicable for different ranges of input data with acceptable level of accuracy, is needed. In order to develop such model for the gasifier, as the ma...
متن کاملControl of a Fluidized Bed Polyethylene Reactor
In present paper, dynamic behavior and control of a fluidized bed reactor for polyethylene production has been considered. A double active sites model for Ziegler-Natta catalysts is used for simulation of polymerization reaction. Hydrodynamic behavior of the bed is modeled using a two phase model including bubble and emulsion phases in which bubble phase has plug flow pattern with different...
متن کاملSimulation of Biomass Gasification in Fluidized Bed Using Aspen Plus
Gasification is a thermo-chemical process to convert carbon-based compounds such as biomass and coal into a gaseous fuel. Among the various types of gasification methods, fluidized bed gasification is one which is considered as more efficient method than others as biomass is fluidized in a mixture of air/oxygen and steam. In the present study, a comprehensive steady state process model has been...
متن کاملA Pilot Study of Syngas Production from Bio-oil Thermal Cracking in a Bubbling Fluidized Bed Reactor
A fluidized bed reactor that is operating in the bubbling regime has been developed for the conversion of bio-oils to syngas.The reactor consists of a 7.6 cm I.D. (or internal diameter) bed, with an expanded freeboard. The volume of the reactor can be adjusted to vary the gas residence time. This reactor has been used to carry out either thermal or catalytic cracking for reforming bio-oils.A ga...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Linköping electronic conference proceedings
سال: 2022
ISSN: ['1650-3740', '1650-3686']
DOI: https://doi.org/10.3384/ecp192051