Simulation and experiments of abrasive assisted electrochemical jet machining of SiC reinforced aluminum matrix composites

Casting of SiC Reinforced Metal Matrix Composites

Composites based on two aluminium alloys (A536 and 6061) reinforced with 10% or 20% volume fraction of SiC particles were produced by gravity casting and a novel two-step mixing method was applied successfully to improve the wettability and distribution of the particles. The SiC particles were observed to be located predominantly in the interdendrit ic regions, and a thermal lag model is propos...

Study on Machining Parameters of TiB2 Reinforced Aluminum 6063 Composites

In this experimental study, three TiB2/Al metal matrix composites (MMCs) with 40 μm in mean size were produced using a melt stirring squeeze casting route. Test was carried out to find the parameters influencing surface roughness (Ra) and material removal rate (MRR) on machining the TiB2 reinforced Al-6063 composite materials. The orthogonal array, the signal-to-noise ratio, and analysis of var...

Laser Drilling Assisted with Jet Electrochemical Machining

Machining of FRP Composites by Abrasive Jet Machining Optimization Using Taguchi

Abrasive Jet Machining is an Unconventional machining process in which the metal is removed from brittle and hard material in the form of micro-chips. With increase in need of materials like ceramics, composites, in manufacturing of various Mechanical & Electronic components, AJM has become a useful technique for micro machining. The present study highlights the influence of different parameter...

Fatigue crack growth resistance in SiC particulate and whisker reinforced P/M 2124 aluminum matrix composites

Fatigue crack growth is examined in P/M 2124 aluminum alloys reinforced with SiC particles (SiCp) and whiskers (SiCw) over a wide spectrum of growth rates from 10 to 10 m per cycle. Effects of aging treatment, orientation of crack growth direction with respect to the rolling direction, mean stress (or stress ratio), and reinforcement volume percent on the fatigue crack growth threshold are inve...