Simulation Analysis of Orthogonal Metal Cutting Process
نویسندگان
چکیده
منابع مشابه
Analysis of Orthogonal Metal Cutting Processes
The orthogonal metal cutting process for a controlled contact tool is simulated using a limit analysis theorem. The basic principles are stated in the form of a primal optimization problem with an objective function subjected to constraints of the equilibrium equation, its static boundary conditions and a constitutive inequality. An Eulerian reference co-ordinate is used to describe the steady ...
متن کاملnumerical simulation of orthogonal cutting process and determination of built up layer thickness
the built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. the built up layer (bul) is formed in second deformation zone near the tool-chip interface in the back of the chip. this parameter influences the tool life and machined surface quality. this bul should not be confused with the built up edge (bue). the deformation of the bul in...
متن کاملOn the separation criteria in the simulation of orthogonal metal cutting using the finite element method
This paper aims to gain an understanding of the reliability of the existing separation criteria for orthogonal metal cutting. To focus on their physical inherence, a simple finite element model under plane-strain deformation was used to investigate the mechanics of cutting from the incipient stage. The workpiece materials studied were elastic–perfectly plastic and elastic–plastic with work hard...
متن کاملMathematical Modeling of Metal Cutting Process
In the practice of metal treatment by cutting it is frequently necessary to deal with selfexcited oscillations of the cutting tool, treated detail and units of the machine tool. In this paper are presented differential equations with the delay of self-excited oscillations. The linear analysis is performed by the method of D-expansion. There is chosen an area of asymptotically stability and area...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Precision Engineering
سال: 1976
ISSN: 0374-3543
DOI: 10.2493/jjspe1933.42.340