Simplified Calculation Formulae for Involute Tooth Form Factor. Based on JGMA 6101-01 Standard.
نویسندگان
چکیده
منابع مشابه
application of upfc based on svpwm for power quality improvement
در سالهای اخیر،اختلالات کیفیت توان مهمترین موضوع می باشد که محققان زیادی را برای پیدا کردن راه حلی برای حل آن علاقه مند ساخته است.امروزه کیفیت توان در سیستم قدرت برای مراکز صنعتی،تجاری وکاربردهای بیمارستانی مسئله مهمی می باشد.مشکل ولتاژمثل شرایط افت ولتاژواضافه جریان ناشی از اتصال کوتاه مدار یا وقوع خطا در سیستم بیشتر مورد توجه می باشد. برای مطالعه افت ولتاژ واضافه جریان،محققان زیادی کار کرده ...
15 صفحه اولBending strength simulation of asymmetric involute tooth gears
In order to enhance the load capacity of gears, researchers take notice in the asymmetric tooth gears. Asymmetric gear which has higher pressure angle of back tooth aiming to improve banding strength has been analyzed (Deng, et al., 2003). Brown et al. (Brown, et al., 2010) investigate the asymmetric tooth from both point of view of bending and scuffing. Kruger et al. (Kruger et al., 2013) anal...
متن کاملPion Electromagnetic Form Factor in the KT Factorization Formulae
Based on the light-cone (LC) framework and the kT factorization formalism, the transverse momentum effects and the different helicity components’ contributions to the pion form factor Fπ(Q) are recalculated. In particular, the contribution to the pion form factor from the higher helicity components (λ1 + λ2 = ±1), which come from the spinspace Wigner rotation, are analyzed in the soft and hard ...
متن کاملApproximate Closed-form Formulae for Buckling Analysis of Rectangular Tubes under Torsion
The buckling torque may be much less than the yield torque in very thin rectangular tubes under torsion. In this paper, simple closed-form formulae are presented for buckling analysis of long hollow rectangular tubes under torsion. By the presented formulae, one can obtain the critical torque or the critical angle of twist of the tube in terms of its geometrical parameters and material constant...
متن کاملA New Statistical Model for Predicting Tooth Engagement and Load Sharing in Involute Splines
Load-sharing among the teeth of involute splines is little understood. Designers typically assume only a fraction of the teeth are engaged and distribute the load uniformly over the assumed number of engaged teeth. This procedure can widely overor underestimate tooth loads. A new statistical model for involute spline tooth engagement has been developed and presented earlier, which takes into ac...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1999
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.65.2867