Silylation Process for Quarter Micron Lithography.
نویسندگان
چکیده
منابع مشابه
The Quality and Reliability of Intel’s Quarter Micron Process
This paper describes how the quality and reliability of Intel’s products are designed, measured, modeled, and maintained. Four main reliability topics: ESD protection, electromigration, gate oxide wearout, and the modeling and management of mechanical stresses are discussed. Based on an analysis of the reliability implications of device scaling (the process of a planned reduction of dimensions ...
متن کاملA Process Control Methodology Applied to Sub-micron Gate Lithography in Manufacturing GaAs MMlCs
While many useful tools for pursuing process control exist, little has been written to guide manufacturing organizations in using these tools to realize process control on a facility wide basis; Consequently, many organizations fail to realize significant process improvement despite repeated attempts. To fill this gap, a methodology for guiding process driven manufacturing organizations in inst...
متن کاملNonstationary carrier dynamics in quarter-micron Si MOSFETs
An application of fuli Monte Carlo modeling to quarter-micron Si MOSFETs is given Nonstationary carrier transport is shown to dominate in 0.4 pm or less channel devices, with peak velocities exceeding I X lo7 cm/sec. The calculated results agree well with experimental values for a device with 0.15 pm channel length and 2.5 nm gate oxide thickness.
متن کاملThermal Channel Noise of Quarter and Sub-Quarter Micron NMOS FET’s
We present a simple and efficient method for the extraction of thermal channel noise of MOS FET’s in quarter and sub-quarter micron technologies from NF50 (noise figure at 50 Ohm source resistance) measurements. For shorter channel lengths the experimental results shows a continuously rising deviation from the classical long channel theory [1]. For a 0.18 μm technology a γ≈6 instead of 2/3 in s...
متن کاملOn-Chip ESD Protection Design for GHz RF Integrated Circuits by Using Polysilicon Diodes in sub-quarter-micron CMOS Process
ESD protection in RF integrated circuits has several considerations: low parasitic capacitance, constant input capacitance, and insensitive to substrate coupling noise. In this paper, a new ESD protection design with polysilicon diodes for RF IC applications is proposed and characterized. The proposed polysilicon diode is constructed by polysilicon layer in a general CMOS process with a central...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Photopolymer Science and Technology
سال: 1992
ISSN: 0914-9244,1349-6336
DOI: 10.2494/photopolymer.5.141