Silicon nitride O-band (de)multiplexers with low thermal sensitivity
نویسندگان
چکیده
منابع مشابه
Pattern Photoresist Silicon Silicon Nitride Silicon Photoresist Silicon Nitride Silicon Etch Nitride Remove Photoresist
In this proposal we seek to establish a porous silicon based etching process in the WTC microfabrication laboratory. The new process will allow us to etch high aspect ratio holes through a wafer. Holes like these are important for decreasing the dead volume of connections between micro and macro systems and for increasing the complexity of micro-fluidic systems. At the present time, the minimum...
متن کاملLow Temperature Sintering Additives for Silicon Nitride
This work deals with sintering additives for the low temperature pressureless sintering of Si3N4, via a transient liquid technique. Much attention has been given to the development of a sintering process using low-cost Si3N4 powder (Silzot HQ, Germany) as the starting material and employing sintering additives which are also both economically attractive and enable sintering at low temperatures....
متن کاملVisible photonic band gap engineering in silicon nitride waveguides
We demonstrate experimentally the tuning of complete photonic band gaps in patterned silicon nitride waveguides. Transmission measurements were performed using an ultrabroadband high-brightness white light laser continuum, extracting extinction ratios as low as 10 in the gap regions. Angle-resolved measurements show the perfect alignment of the gap around the G-J direction. © 2000 American Inst...
متن کاملThermal conductivity of micromachined low-stress silicon-nitride beams from 77 to 325 K
We present thermal conductivity measurements of micromachined 500 nm thick silicon-nitride Si–N beams suspended between two Si–N islands, in the temperature range from 77 to 325 K. The measured thermal conductivity, k, of Si–N at high temperatures is in good agreement with previously measured values for Si–N grown by low-pressure chemical vapor deposition, but behaves much differently as temper...
متن کاملDetermining the thin-film thermal conductivity of low temperature PECVD silicon nitride
The design and optimization of micromachined thermal sensors often requires information on accurate material properties of the used thin-films. These data can differ considerably from those stated for bulk matter and are strongly process-dependent. In this contribution a micromachined canitlever structure is proposed, which allows to directly determine the thermal conductivity of dielectric thi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Optics Express
سال: 2017
ISSN: 1094-4087
DOI: 10.1364/oe.25.012260