Signal-to-noise ratio in chirped laser dispersion spectroscopy
نویسندگان
چکیده
منابع مشابه
Signal-to-noise ratio in chirped laser dispersion spectroscopy.
Quantitative studies and experimental validation of noise sources occurring in chirped laser dispersion spectroscopy (CLaDS) are reported. Their impact on the signal-to-noise ratio (SNR) achievable with the CLaDS sensing method is analyzed through a noise model supported by experimental results. In particular the model shows that the SNR is optimal for a given value of the laser chirp rate. The...
متن کاملSignal-to-noise ratio in squeezed-light laser radar.
The formalism for computing the signal-to-noise ratio (SNR) for laser radar is reviewed and applied to the tasks of target detection, direction finding, and phase-change estimation with squeezed light. The SNR for heterodyne detection of coherent light using a squeezed local oscillator is lower than that obtained using a coherent local oscillator. This is true for target detection, for phase es...
متن کاملSignal-to-Noise Ratio Estimation
Of the many measures that characterize the performance of a communication receiver, signal-to-noise ratio (SNR) is perhaps the most fundamental in that many of the other measures directly depend on its knowledge for their evaluation. In the design of receivers for autonomous operation, it is desirable that the estimation of SNR take place with as little known information as possible regarding o...
متن کاملSignal-to-noise ratio in MRI.
in RF receiving coil design. However, modern is proportional to 0 , so that their population imaging techniques often demand very high speed difference is larger at high values of 0 . Since the and spatial resolution, so that the highest possible ratio of the energy difference to thermal energy is SNR is still required to avoid poor image quality. very small, the population difference increases...
متن کاملChirped Laser Dispersion Spectroscopy for Remote Open-Path Trace-Gas Sensing
In this paper we present a prototype instrument for remote open-path detection of nitrous oxide. The sensor is based on a 4.53 μm quantum cascade laser and uses the chirped laser dispersion spectroscopy (CLaDS) technique for molecular concentration measurements. To the best of our knowledge this is the first demonstration of open-path laser-based trace-gas detection using a molecular dispersion...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Optics Express
سال: 2011
ISSN: 1094-4087
DOI: 10.1364/oe.20.000644