Signal to Noise Ratio Analysis in Virtual Source Array Imaging
نویسندگان
چکیده
منابع مشابه
Signal to Noise Ratio Analysis in Virtual Source Array Imaging
We consider correlation-based imaging of a reflector located on one side of a passive array where the medium is homogeneous. On the other side of the array the illumination by remote impulsive sources goes through a strongly scattering medium. It has been shown in [J. Garnier and G. Papanicolaou, Inverse Problems, 28 (2012), 075002] that migrating the cross correlations of the passive array giv...
متن کاملSignal-to-noise ratio and signal-to-noise efficiency in SMASH imaging.
A general theory of signal-to-noise ratio (SNR) in simultaneous acquisition of spatial harmonics (SMASH) imaging is presented, and the predictions of the theory are verified in imaging experiments and in numerical simulations. In a SMASH image, multiple lines of k-space are generated simultaneously through combinations of magnetic resonance signals in a radiofrequency coil array. Here, effects ...
متن کاملSignal to Noise Ratio in Lensless Compressive Imaging
We analyze the signal to noise ratio (SNR) in a lensless compressive imaging (LCI) architecture. The architecture consists of a sensor of a single detecting element and an aperture assembly of an array of programmable elements. LCI can be used in conjunction with compressive sensing to capture images in a compressed form of compressive measurements. In this paper, we perform SNR analysis of the...
متن کاملSignal-to-Noise Ratio Estimation in Passive Correlation-Based Imaging
We consider here the problem of imaging using passive incoherent recordings due to ambient noise sources. The first step towards imaging in this configuration is the computation of the cross-correlations of the recorded signals. These cross-correlations are computed between pairs of sensors (receivers) and they contain very important information about the background medium. Indeed, it was shown...
متن کاملOptimization of Imaging Parameters in Micro-CT Scanner Based On Signal-To-Noise Ratio for the Analysis of Urinary Stone Composition
Introduction: Micro-CT scanner with a resolution of about 5 micrometers is one of the modalities used to create three-dimensional/two-dimensional images of urinary stones. This study aimed to optimize imaging parameters in micro-computed tomography (CT) scanner based on the signal-to-noise ratio (SNR) of urinary stones for the analysis of stone composition. <stro...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: SIAM Journal on Imaging Sciences
سال: 2015
ISSN: 1936-4954
DOI: 10.1137/140968677