Signal processing for picosecond resolution timing measurements
نویسندگان
چکیده
منابع مشابه
Signal Processing for Pico-second Resolution Timing Measurements
The development of large-area homogeneous photo-detectors with sub-millimeter path lengths for direct Cherenkov light and for secondary-electrons opens the possibility of large time-of-flight systems for relativistic particles with resolutions in the pico-second range. Modern ASIC techniques allow fast multi-channel front-end electronics capable of sub-pico-second resolution directly integrated...
متن کاملAn Embedded Core for Sub-Picosecond Timing Measurements
The continued market demand for GHz processors and high-capacity communication systems results in an increasing number of low-cost high volume ICs with multi-GHz clocks and/or multi-Gb/s serial communication interfaces. For such devices, timing specifications, e.g., jitter and skew, in the range of few picoseconds (RMS and/or p-p) are common. We describe an embedded core that allows such measur...
متن کاملColliding Pulse Phase Detector for Picosecond Resolution Timing Measurement
single tap actually consists or four diodes distributed at 2 pS effective delay time along the line and tied together at the tap output. Fig. 2 shows the evolutio.n or the coincidence or two input pulses. The peak detector taps are biased such that neither the clock nor the trigger signal alone is large enough in amplitude to cause forward bias or the peak detector taps. This is the case at tim...
متن کاملReview of methods for time interval measurements with picosecond resolution
This paper is a review of methods and techniques used for precise measurement of time intervals (TIs) or precise conversion of TIs to digital data. The following methods are described: the counter method and averaging, time stretching, time-to-amplitude conversion followed by analogue-to-digital conversion, the Vernier method, conversion utilizing tapped delay lines, and interpolation methods. ...
متن کاملdesign of an analog ram (aram)chip with 10-bit resolution and low-power for signal processing in 0/5m cmos process
برای پردازش سیگنال آنالوگ در شبکه های عصبی ، معمولا نیاز به یک واحد حافظه آنالوگ احساس میشود که بدون احتیاج به a/d وd/a بتواند بطور قابل انعطاف و مطمئن اطلاعات آنالوگ را در خود ذخیره کند. این واحد حافظه باید دارای دقت کافی ، سرعت بالا ، توان تلفاتی کم و سایز کوچک باشد و همچنین اطلاعات را برای زمان کافی در خود نگهدارد. برای پیاده سازی سیستمی که همه این قابلیتها را در خود داشته باشد، کوشش...
15 صفحه اولذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
سال: 2009
ISSN: 0168-9002
DOI: 10.1016/j.nima.2009.05.193