Shrinkage Kinetics during Sintering W-Ni-Fe Heavy Alloy with Ultrafine Grain
نویسندگان
چکیده
منابع مشابه
Nanostructurization of Fe-Ni Alloy
Data about an effect of cyclic γ-α-γ martensitic transformations on the structure state of reverted austenite Fe-31.7 wt.% Ni-0.06 wt.% C alloy are presented. The effect of multiple direct γ-α and reverse α-γ martensitic transformations on fragmentation of austenitic grains has been investigated by electron microscopy and X-ray diffraction methods. An ultrafine structure has been formed by nano...
متن کاملUltrafine-Grained Structure of Fe-Ni-C Austenitic Alloy Formed by Phase Hardening
The X-ray and magnetometry methods were used to study α-γ transformation mechanisms on heating quenched Fe-22.7 wt.% Ni-0.58 wt.% С alloy. Variation of heating rate within 0.03-80 K/min allowed one to switch from diffusive to non-diffusive mechanism of the α-γ transformation. Heating up primary austenitic single crystal specimen at a rate of less than 1.0-0.5 K/min has led to formation of aggre...
متن کاملDEVELOPMENT OF A TUNGSTEN HEAVY ALLOY, W-Ni-Mn, USED AS KINETIC ENERGY PENETRATOR
Abstract: The objective of this research was to develop a tungsten heavy alloy (WHA) having a microstructure and properties good enough to penetrate hard rolled steels as deep as possible. In addition this alloy should not have environmental problems as depleted uranium (DU) materials. For this purpose a wide spread literature survey was performed and on the base of information obtained in ...
متن کاملPRESSURELESS SINTERING OF B4C-NANOTiB2 NANOCOMPOSITE BY ADDITION OF Fe AND Ni AS SINTERING AIDS
B4C and its composites with TiB2 as second phase continues to be extensively used as the preferred ceramic material in military applications as armor systems for absorbing and dissipating kinetic energy from high velocity projectiles. It also exhibits a high melting point (2427 °C), and high neutron absorption cross section. Pressureless sintering of the B 4C-nanoTiB2 nanocomposite using small ...
متن کاملIn-situ measurements of grain rotation during annealing in ultrafine grained aluminum alloy
We present the results of in-situ studies of evolution of grain boundary misorientations in ultrafine grained (UFG) aluminum alloy Al-4 Cu-0.5 Zr (wt%) during annealing. The structure of the UFG alloy was obtained by severe plastic deformation method. Misorientations between the grains were measured using single reflection technique. It was found that relaxation processes during annealing are a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 2003
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.50.912