Short-term high-temperature creep of Grade 5 titanium alloy heated in air and argon
نویسندگان
چکیده
منابع مشابه
the effects of keyword and context methods on pronunciation and receptive/ productive vocabulary of low-intermediate iranian efl learners: short-term and long-term memory in focus
از گذشته تا کنون، تحقیقات بسیاری صورت گرفته است که همگی به گونه ای بر مثمر ثمر بودن استفاده از استراتژی های یادگیری لغت در یک زبان بیگانه اذعان داشته اند. این تحقیق به بررسی تاثیر دو روش مختلف آموزش واژگان انگلیسی (کلیدی و بافتی) بر تلفظ و دانش لغوی فراگیران ایرانی زیر متوسط زبان انگلیسی و بر ماندگاری آن در حافظه می پردازد. به این منظور، تعداد شصت نفر از زبان آموزان ایرانی هشت تا چهارده ساله با...
15 صفحه اولArgon-shielded hot pressing of titanium alloy (Ti6Al4V) powders.
The paper presents the method of the argon - shielded hot pressing of titanium alloy (Ti6A14V) powder (used in medical industry). The powders produced in the GA (gas atomization) process and in the HDH (hydride - dehydride) process were used in the experiments. A pressing process was conducted at a temperature of 800-850 degrees C for different lengths of time. An unoxidized sintered material, ...
متن کاملthe effects of collaborative strategic reading and direct instruction in persuasion on iranian second grade of high school students persuasive writing and attitudes
this study examined the effects of collaborative strategic reading and direct instruction in persuasion on iranian high school students persuasive writing and attitudes. students in three intact classes were assigned to one of three treatment conditions: collaborative strategic reading and direct instruction in persuasion or direct instruction in persuasion or a control group. treatment effects...
effects of tool material on the machinability of titanium (grade-5) alloy by using rsm
this paper presents the findings of experimental investigations into the effects of cutting speed, feed rate, depth of cut and approach angle on the machinability of titanium (grade-5) alloy. also the comparison for the two different cutting materials inserts polycrystalline diamond (pcd) and cubic boron nitride (cbn) with similar tool geometry for similar machining parameters is also carried o...
متن کاملFatigue and corrosion fatigue properties of Ti-6Al-4V implant grade titanium alloy in Ringer solution
Nowadays modification of metallic biomaterials which are used as implants for bone and hard tissues replacement is considered as an important subject. In the current study, corrosion fatigue properties of Ti-6Al-4V alloy investigated via Rotating-Bending standard test method and then, the results compared with the fatigue properties of the specimens tested in the same conditions. Scanning elect...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Letters on Materials
سال: 2019
ISSN: 2218-5046,2410-3535
DOI: 10.22226/2410-3535-2019-3-294-298