Short Beam Three Point Bending Test on Hot-Dip Aluminized SUS316 Stainless Steel
نویسندگان
چکیده
منابع مشابه
Elastic modulus of a triple-stranded stainless steel arch wire via three- and four-point bending.
The modulus of elasticity (E) was determined in simple three- and four-point bending for an 0.0175" (3 X 0.008") stainless steel arch wire. Using variable light loads (10-160 g) to limit the elastic deflection of a wire to less than 5% of its beam length, the force-deflection profiles were determined for three nominal span lengths (L = 0.35", 0.75", and 1.00") in three-point bending and three n...
متن کاملTitanium-Aluminum Oxide Coating on Aluminized Steel
In this study, a plasma electrolytic oxidation (PEO) process was used to form titanium-aluminum oxide coating on aluminized steel. The present work was mainly to study the effects of treatment time of PEO process on properties of the titanium coating. A potentiodynamic polarization corrosion test was employed to investigate the corrosion resistance of the coating. The friction coefficient and w...
متن کاملMODIFICATION INFLUENCE OF MISCHMETAL ON FRACTOGRAPHY FRACTURE OF G17CrMo5-5 CAST STEEL SAMPLES AFTER THE THREE-POINT BENDING TEST
J. Kasińska, Faculty of Mechatronics and Machine Design, Kielce University of Technology, Kielce, Poland The article presents the analysis of fracture surfaces after the three-point bending test at a temperature range from + 20 °C to 80 °C. The author shows a beneficial effect of mischmetal on the cracking mechanism and on the character of fractures. It has been shown that the width of the duct...
متن کاملDynamic recrystallization kinetics of AISI 403 stainless steel using hot compression test
In this work dynamic recrystallization behavior of AISI 403 martensitic stainless steel was studied using hot compression tests over temperature range of 900 C -1200 C and strain rate range of 0.001 s-1 - 1 s-1. The obtained flow curves showed that the hot compression behavior of the alloy is controlled by dynamic recrystallization. The flow stress and strain corresponding to the critical, pe...
متن کاملCompressibility of 304 Stainless Steel Powder Metallurgy Materials Reinforced with 304 Short Stainless Steel Fibers
Powder metallurgy (P/M) technique is usually used for manufacturing porous metal materials. However, some P/M materials are limitedly used in engineering for their performance deficiency. A novel 304 stainless steel P/M material was produced by a solid-state sintering of 304 stainless steel powders and 304 short stainless steel fibers, which were alternately laid in layers according to mass rat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1994
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.58.2_242