Short Amorphous Micro-Wires Magnetic Properties and Structure.
نویسندگان
چکیده
منابع مشابه
On Structure and Properties of Amorphous Materials
Mechanical, optical, magnetic and electronic properties of amorphous materials hold great promise towards current and emergent technologies. We distinguish at least four categories of amorphous (glassy) materials: (i) metallic; (ii) thin films; (iii) organic and inorganic thermoplastics; and (iv) amorphous permanent networks. Some fundamental questions about the atomic arrangements remain unres...
متن کاملMagnetic properties of amorphous Ni60Ag40 films
Amorphous Ni–Ag films were obtained on liquid nitrogen cooled Si substrates using DC magnetron sputtering. A series of magnetic and magneto-transport property measurements confirm that the film with Ni to Ag atomic ratio of 60:40 is an alloy of the two elements immiscible in equilibrium, with atomic-level intermixing. The magnetic properties of the new alloy are discussed in comparison with tho...
متن کاملFermions and Bosons in Superconducting Amorphous Wires
We discuss the destruction of superconductivity in quasi-one-dimensional systems due to the interplay between disorder and Coulomb repulsion. We argue that to understand the behavior of the system one has to study both fermionic and bosonic mechanisms of suppression of superconductivity. The former describes reduction in the mean field critical temperature Tc, while the latter refers to thermal...
متن کاملIntroducing and investigating structural and magnetic properties of ribbons Co68.5-xFe4WxSi16.5B11 (x = 0.8, 2) in amorphous and crystalline states
In this study, for the first time, cobalt base ribbons were made by adding two different amounts of tungsten with Co67.7Fe4W0.8Si16.5B11 and Co66.5Fe4W2 Si16.5B11 compounds by melt spinning in the water. The pattern of X-ray diffraction taken from these ribbons shows that these magnetic ribbons are amorphous. By using thermal analysis curves, taken from the ribbons, crystallization temperature...
متن کاملStructure, composition, and mechanical properties of Australian orthodontic wires.
OBJECTIVE To investigate the surface morphology, structure, elemental composition, and key mechanical properties of various sizes and tempers of Australian wires. MATERIALS AND METHODS Three types of Australian wire were used: 0.016'' regular, 0.018'' regular+, and 0.018'' special+ (A.J. Wilcock, Whittlesea, Victoria, Australia). Each type of wire was subjected to scanning electron microscopy...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Magnetics Society of Japan
سال: 1999
ISSN: 0285-0192
DOI: 10.3379/jmsjmag.23.628