Shift of Creep Mechanism in Nanocrystalline NiAl Alloy
نویسندگان
چکیده
منابع مشابه
Tensile Creep of Polycrystalline Near-Stoichiometric NiAl
Long term tensile creep studies were conducted on binary NiAl in the temperature range 700-1200 K with the objectives of characterizing and understanding the creep mechanisms. Inverse and normal primary creep curves were observed depending on stress and temperature. It is concluded that the primary creep of NiAl is limited by dislocation mobility. The stress exponent for creep, n, decreased fro...
متن کاملMeasurement and Modeling of Creep in Open-Cell NiAl Foams
Nickel-rich NiAl foams, consisting of open cells with hollow struts and exhibiting two relative densities (5.0 and 6.6 pct) and average cell sizes (1.27 and 0.85 mm), were creep tested between 800 °C and 1100 °C under compressive stresses between 0.10 and 1.50 MPa. For stresses lower than 0.50 MPa, the foams exhibit secondary creep with power-law behavior characterized by creep exponents and ac...
متن کاملReactive Infiltration Processing and Secondary Compressive Creep of NiAl and NiAl-W Composites
Reactive infiltration processing was used to fabricate bulk NiAl and fiber-reinforced NiAl composites. Homogenous, pore-free materials were obtained by chemical reaction between nickel and aluminum after complete infiltration with liquid aluminum of preforms of nickel wires (containing tungsten wires for the composites) with low surface-to-volume ratio, high permeability, and regular infiltrati...
متن کاملReactive Infiltration Processing and Compression Creep of NiAl and NiAl Composites
....................................... 2 TA BLE O F C O N TEN TS ................................................................................................. ..................................... 3 LIST OF FIGURES .................................. ............................... ....... ......................... 5 LIST O F T A B LE S .........................................................
متن کاملTransformation-Induced Creep and Creep Recovery of Shape Memory Alloy
If the shape memory alloy is subjected to the subloop loading under the stress-controlled condition, creep and creep recovery can appear based on the martensitic transformation. In the design of shape memory alloy elements, these deformation properties are important since the deflection of shape memory alloy elements can change under constant stress. The conditions for the progress of the marte...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials
سال: 2019
ISSN: 1996-1944
DOI: 10.3390/ma12162508