Sheet Forming Simulation Using Static Explicit FEM Program Coupled with Elastic Deformation of Tools
نویسندگان
چکیده
منابع مشابه
Forming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کامل1.7 FEM Simulation of the forming of parts from thick sheet
According the projectplan the forming of a thick sheet metal part typical for DAF will be investigated. The batteryboxbracket (Figure 1) has been chosen, which is already over ten years in production and proved to be critical. This part is fixed with bolts to the chassis of the truck and supports the batterybox (Figure 2). The initial thickness of the blank is 5mm. The length of the part and th...
متن کاملFEM Simulation of Dynamic Sliding of Faults Connecting Static Deformation Process to Dynamic Process
The objective of present study is to develop a finite element method (FEM) software system toward a large-scale computation of following seismic processes: (1) Accumulation of the stress around active faults in the crust, which is induced by a subduction of plates in a long time span (static deformation process); (2) Onset of an earthquake due to a dynamic sliding on the faults, which is induce...
متن کاملAn overview of stabilizing deformation mechanisms in incremental sheet forming
In Incremental Sheet Forming (ISF) strains can be obtained well above the Forming Limit Curve (FLC) that is applicable to common sheet forming operations like deep drawing and stretching. This paper presents an overview of mechanisms that have been suggested to explain the enhanced formability. The difference between fracture limit and necking limit in sheet metal forming is discussed. The neck...
متن کاملSHEET ELECTROMAGNETIC FORMING USING CONVEX PUNCH INSTEAD OF CONVAVE DIE
High speed and absence of a precise control over pressure distribution confine sheet Electromagnetic Forming into a die to simple shapes having shallow depth. It is possible to reach a higher depth by using a convex punch instead of a concave die. In this study, sheet Electromagnetic Forming on a punch and sheet Electromagnetic Forming into a die are investigated. The electromagnetic part of th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Technology of Plasticity
سال: 2006
ISSN: 0038-1586,1882-0166
DOI: 10.9773/sosei.47.64