Shear Stress Distribution Analysis in Cold Formed Material
نویسندگان
چکیده
منابع مشابه
Predicting Shear Stress Distribution in Rectangular Channels Using Entropy Concept
This study makes use of the Tsallis entropy to predict the shear stress distribution. Given a definition of the Tsallis entropy, it is maximized by using the probability density function, which then is used to attain a novel shear stress equation. This is then employed for calculating the shear stress distribution in rectangular channels in different aspect ratios and finally, for viability, th...
متن کاملSimplified Models for the Material Characterization of Cold-Formed RHS
It is well known that the cold-forming process used to manufacture tubes causes an increase in both the yielding stress and the ultimate strength of the corner material in rectangular steel hollow sections. This may have a significant effect on the resistance of any structure built with those profiles. However, the mentioned material hardening can be difficult to take into account in the calcul...
متن کاملStress Analysis and Energy Estimation in Cold-Roll Forming Process
In this article, stress analysis and energy estimation during cold-roll forming of symmetrical channel sections have been discussed. Geometry of sheet strip is pre-estimated by a shape function. Then longitudinal, transversal and shear strains have been calculated. Using both the Levy-Mises and the Prandtl Reuss equations, and also considering the Bauschinger effect, stress distributions have b...
متن کاملStress Analysis and Energy Estimation in Cold-Roll Forming Process
In this article, stress analysis and energy estimation during cold-roll forming of symmetrical channel sections have been discussed. Geometry of sheet strip is pre-estimated by a shape function. Then longitudinal, transversal and shear strains have been calculated. Using both the Levy-Mises and the Prandtl Reuss equations, and also considering the Bauschinger effect, stress distributions have b...
متن کاملThe Effect of Post Material on Stress Distribution in Mandibular Second Premolar Tooth by Finite Element Analysis
Introduction: The restoration material commonly used as core material for pulpless posterior teeth is mostly amalgam due to its high strength and low cost and it can be used with or without pin. The aim of this study was to evaluate the influence of post material on stress distribution in mandibular second premolar tooth by finite element analysis. Method: The stress distribution was analyzed i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2015
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2015.01.340