Shear Strength of Exterior Plywood Panels Pressed at Low Temperature
نویسندگان
چکیده
منابع مشابه
Shear Strength of Exterior Plywood Panels Pressed at Low Temperature
Plywood manufactured from thin veneer sheets of different species is one of the most traditional structural composite panels. The objective of this study was to produce experimental plywood panels using a temperature of 100 °C, which is 10 to 30% lower than typical press temperature of plywood manufacture. It was determined that shear strength characteristics of the samples were not adversely i...
متن کاملShear bond strength of a hot pressed Au-Pd-Pt alloy-porcelain dental composite.
OBJECTIVES The purpose of this study was to evaluate the effect of hot pressing on the shear bond strength of a Au-Pt-Pd alloy-porcelain composite. METHODS Several metal-porcelain composites specimens were produced by two different routes: conventional porcelain fused to metal (PFM) and hot pressing. In the latter case, porcelain was hot pressed onto a polished surface (PPPS) as well as a rou...
متن کاملIdentification of Low Cycle Fatigue Parameters of High Strength Low-alloy (hsla) Steel at Room Temperature
S. Bulatović, Yugoslav River Shipping, Serbia, Lj. Milović, University of Belgrade, Faculty of Technology and Metallurgy, Serbia, A. Sedmak, University of Belgrade, Faculty of Mechanical Engineering, Serbia, I. Samardžić, University of Osijek, Mechanical Engineering Faculty, Slavonski Brod, Croatia Low cycle fatigue test was performed in ambient atmosphere at room temperature. Cycle loading of ...
متن کاملShear Localization due to Strain Softening in Side Pressed Cylinders
In this paper, shear localization due to strain softening in sidepressed cylinders, is inverstigated. Shear localization causes formation of macroscopic shear bands which can be obsserved in the metallographic cross-section. In this paper, for the first time a method is presented in which a simple two-slice model is used to study the formation of shear bands. The results obtained form this mode...
متن کاملShear Localization due to Strain Softening in Side Pressed Cylinders
In this paper, shear localization due to strain softening in sidepressed cylinders, is inverstigated. Shear localization causes formation of macroscopic shear bands which can be obsserved in the metallographic cross-section. In this paper, for the first time a method is presented in which a simple two-slice model is used to study the formation of shear bands. The results obtained form this mode...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials
سال: 2009
ISSN: 1996-1944
DOI: 10.3390/ma2030876