SHEAR STRENGTH CHARACTERISTICS OF ULTRA SOFT CLAY GROUND USING CENTRIFUGE
نویسندگان
چکیده
منابع مشابه
Viscous Rate Effects in Shear Strength of Clay
Viscous rate effects are commonly observed in clay soils in applications that involve high strain rates such as free falling penetrometer tests. Viscous rate effects are not well studied thus affecting reliable interpretation of these applications. This paper presents an investigation of viscous rate effects in clay using laboratory rate studies covering a wide range of strain rates (6 orders o...
متن کاملClassification of Ultra-high Resolution Images using Soft Computing
The main objective of this paper is to use a computational intelligence algorithm for preparing a mapping map that categorizes different patterns of identification of infected areas and changes in radiation pollution. In this paper, the use of the fuzzy inference system has been proposed to determine the degree of radiation contamination in the regions. The study uses ultra-high resolution spec...
متن کاملCentrifuge modelling of sand compaction piles in soft clay under embankment load
Sand compaction piles are used in practice for ground improvement of soft subsoil in order to accelerate consolidation, reduce compressibility, and increase strength. The current design procedure of sand compaction piles is based on simple empirical calculations, which does not take full account of the sand pile behaviour. This research project investigates the behaviour of a base reinforced em...
متن کاملEffect of Moisture Content on Shear Strength of Offshore Clay Interface Steel Surface
This paper investigates the effect of moisture content on interface shear strength between offshore clay and steel plate. Although, sensitive and high plasticity offshore clay deposits are widely distributed in Malaysia and many other countries in the world, and steel is a vital construction material for many structures, research works on interaction between offshore clay and steel surface are ...
متن کاملStrength Characteristics of Clay Mixtures with Waste Materials in Freeze-Thaw Cycles
Waste tires, rubbers, plastic and steel materials, normally produced in every society, enter the environment and cause serious problems. These problems may, to some extent, be reduced by finding applications for them in engineering, for example, they can be used for geotechnical applications as backfill material and solving problems with low shear strength soils. Such materials may be subjected...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Doboku Gakkai Ronbunshuu C
سال: 2006
ISSN: 1880-604X
DOI: 10.2208/jscejc.62.1