Shear resistance and design of stainless steel plate girders in fire

Response of Fire Exposed Steel Bridge Girders

Stainless steel structures in fire

The initial material cost of structural stainless steel is about four times that of structural carbon steel, due largely to the expense of the alloying elements and the relatively low volume of production. Given broadly similar structural performance, additional areas of benefit need to be identified and exploited in order to establish stainless steel as a viable alternative material for constr...

Plastic Analysis and Design of Steel Plate Shear Walls

A revised procedure for the design of steel plate shear walls is proposed. In this procedure the thickness of the infill plate is found using equations that are derived from the plastic analysis of the strip model, which is an accepted model for the representation of steel plate shear walls. Comparisons of experimentally obtained ultimate strengths of steel plate shear walls and those predicted...

Design aspects of steel I-girders with corrugated steel webs

Corrugated web girders represent a new structural system emerged in the past two decades. The girder’s flanges provide the flexural strength of the girder with no contribution from the corrugated web which provides the girder’s shear capacity. Failure of the web occurs by steel yielding, web buckling or interactively between them. Lateral torsion and local flange buckling of corrugated web gird...

Comparison of plasticity and stiffness of steel shear walls with composite steel plate shear wall

The steel shear wall and composite steel plate shear wall is introduced in recent three decade and is considered and is spread rapidly. Composite steel plate shear wall which is made of a layer of thin steel sheet with coating of reinforced concrete in one or both sides of steel palate is considered a third generation of resistance shear walls against lateral loads that in addition to increasin...