Shear Characteristics of Powder Compact by Using Improved Single Shear Test
نویسندگان
چکیده
منابع مشابه
Shear strain imaging using shear deformations.
In this article we investigate the generation of shear strain elastograms induced using a lateral shear deformation. Ultrasound simulation and experimental results demonstrate that the shear strain elastograms obtained under shear deformation exhibit significant differences between bound and unbound inclusions in phantoms, when compared to shear strain images induced upon an axial compression. ...
متن کاملImproved Significance Test for DNA Microarray Data: Temporal modulation of endothelial gene expression by shear stress
Statistical methods for identifying differentially expressed genes from microarray data are evolving. We developed a test for the statistical significance of differential expression as a function of time. When applied to microarray data obtained from endothelial cells exposed to shearing for different durations, the new multi-group test (G-test) identified three times as many genes as the one-w...
متن کاملThe Validity Assessment of Laboratory Shear Modulus Using In-Situ Seismic Piezocone Test Results
Seismic piezocone device (SCPTu) together with Resonant Column and Cyclic Triaxial test apparatus are employed to measure small strain shear modulus (G0) of carbonate sandy and clayey soils of southern coasts of Iran. A large area of southern regions of Iran is formed from clay, silt and sand. In this study, maximum shear modulus that is derived from both field (by seismic piezocone) and labora...
متن کاملAcoustic Characteristics of Fatigued Aluminum Alloy Using Ultrasonic Shear Waves
Cyclic-tension fatigue of aluminum alloy, Al-4Cu-1Mg, was determined by an analysis of diffracted SH and SV waves, passing through the surface and reflecting the bottom of the specimen, respectively. The internal friction of SV waves begins to increase from fatigue damage ratio(=N/Nf) of 0.5. This suggests increase of movable dislocation. From the analysis of SH waves, the logarithmic damping r...
متن کاملInvestigation of Vertical Wind Shear Characteristics Using 50m Meteorological Tower Data
Wind measurement is important for estimating wind energy potential, but it is relatively cost-intensive and often conducted at a narrow height from the ground level. The typical range of most turbine hub heights is from 30-50 m or even higher. Extrapolation on wind data thus becomes necessary to estimate the wind speed at different heights. Doing so requires the essential understanding of wind ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 2004
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.70.2555