Shear Bond Strength and Film Thickness of a Naturally Antimicrobial Modified Dental Luting Cement
نویسندگان
چکیده
منابع مشابه
Bond strength of composite luting cement to zirconia ceramic surfaces.
OBJECTIVES To evaluate the bond strength of dental resin agent to zirconia ceramic after surface pre-treatment with different techniques. METHODS Specimens of hot isostatic pressed yttrium-oxide-partially-stabilized zirconia blocks (ZF) were fabricated (Procera Zircon, Nobel Biocare, Sweden) and compared to glossy dense zirconia blocks (ZG). Four groups of specimens with different surface tre...
متن کاملThe Effect of Lithium Disilicate Ceramic Thickness and Translucency on Shear Bond Strength of Light-cured Resin Cement
Introduction: To achieve acceptable clinical performance, a ceramic veneer must be bonded to enamel by well-polymerized resin cement. Among different factors, thickness and translucency of the ceramic may affect the resin cement polymerization. Thus, the current study evaluated the effect of the thickness and translucency of lithium disilicate ceramic on light-cured resin cement bond strength t...
متن کاملDiametral tensile strength and film thickness of an experimental dental luting agent derived from castor oil
UNLABELLED The need to develop new dental luting agents in order to improve the success of treatments has greatly motivated research. OBJECTIVE The aim of this study was to evaluate the diametral tensile strength (DTS) and film thickness (FT) of an experimental dental luting agent derived from castor oil (COP) with or without addition of different quantities of filler (calcium carbonate - CaC...
متن کاملEffect of marginal sealant on shear bond strength of glass ionomer cement: used as a luting agent.
BACKGROUND Moisture sensitivity and dissolution has been a known drawback of glass ionomer cement (GIC). When used as a luting agent for cementation of casted indirect restoration, the exposed cement at the margins is often a primary factor for marginal leakage and consequent failure of the restoration. The following in vitro study was planned to evaluate the effect of a marginal sealant on GIC...
متن کاملShear bond strength of resin modified glass ionomer cement bonded to different tooth-colored restorative materials.
AIM The aim of this study was to determine in vitro the shear bond strength (MPa) and the type of bond failure when resin-modified glass ionomer cement (RMGIC) was bonded with different tooth-colored restorative materials. METHODS AND MATERIALS The RMGIC tested was Fuji II LC (FL) and the tooth-colored restorative materials used were composite resin Point-4 (P4), Compomer Dyract AP (DY), and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Molecules
سال: 2021
ISSN: 1420-3049
DOI: 10.3390/molecules26051276