Shear behaviour and design of Lipped Channel Beams with non-circular web openings
نویسندگان
چکیده
منابع مشابه
Design of composite beams with web openings
ao"length of opening dh, dl"distance from top of steel section to centroid of concrete force at high and low moment ends of the opening, respectively dr"distance from outside edge of flange to centroid of reinforcement *b"maximum bending deflection for unperforated beam *m,b"maximum bending deflection for a member with an opening Fy"yield stress of steel FM y"reduced axial strength of steel in ...
متن کاملSteel Beams with Web Openings
The responsibility of a Structural Engineer lies in not merely designing the structure based on safety and serviceability considerations but he also has to consider the functional requirements based on the use to which the structure is intended. While designing a power plant structure or a multi-storeyed building, the traditional structural steel framing consists of beams and girders with solid...
متن کاملShear Strength of Reinforced Web Openings in Steel Beams
The floor beams of steel buildings, cold-formed steel floor joists in particular, often require large web openings, which may affect their shear capacities. A cost effective way to mitigate the detrimental effects of such openings is to weld/fasten reinforcements. A difficulty associated with an experimental investigation to establish suitable reinforcement schemes for openings in shear zone is...
متن کاملStrengthening of RC Beams with Large Openings in Shear by CFRP Laminates: 2D Nonlinear FE Analysis
To date, theoretical studies concerning the Carbon Fiber Reinforced Polymer (CFRP) strengthening of RC beams with openings have been rather limited. In addition, various numerical analyses presented so far have effectively simulated the behaviour of solid beam strengthened by FRP material. In this paper, a two dimensional nonlinear finite element analysis is presented to validate against the la...
متن کاملAn Analytical Shear Factor for FGM Circular Plates with Non-uniform Elastic Foundations and Normal and Shear Tractions
The available shear correction factors have mainly been developed for homogeneous isotropic plates and/or assuming that no shear tractions are imposed on the top and bottom surfaces of the plate. In the present research, a more general case of a circular functionally graded plate subjected to non-uniform normal and shear tractions at the top and bottom surfaces is considered. These non-uniform ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Thin-Walled Structures
سال: 2017
ISSN: 0263-8231
DOI: 10.1016/j.tws.2017.03.035