Setup for studying the process of cutting materials at low cutting speeds
نویسندگان
چکیده
منابع مشابه
Cutting-Tool Materials and Cutting Fluids
The reasons for the availability of a large variety of cutting-tool materials is best appreciated by reviewing the top eight parameters in the first column in Table 22.2 on p. 638. Among various factors, the type of workpiece material machined, the type of operation, and the surface finish and dimensional accuracy required all affect the choice of a cutting-tool material. For example, for inter...
متن کاملThe Impact of Cutting Tool Materials on Cutting Force
A judicious choice of insert material, tool geometry and cutting conditions can make hard turning produce better surfaces than grinding. In the present study, an attempt has been made to investigate the effect of cutting tool materials on cutting forces (feed force, thrust force and cutting force) in finish hard turning of AISI D2 cold work tool steel. In conclusion of the results obtained with...
متن کاملExperimental Study of the Effect of Laser-Cutting Process Parameters on Heat Distribution and Cutting Edge Quality of Steel Sheets
This study aimed to evaluate Laser-cutting process of Mild Steel St37 sheets with two different thicknesses. In order to evaluate the quality of cutting edge and the depth of the area affected by the heat, several tests were conducted to determine the effect of parameters such as Laser power, Laser beam movement speed and pressure of axillary gas on the quality of cutting edge and the depth of ...
متن کاملWastewater Treatment of Stone Cutting Industries by Coagulation Process
Background & Aims of the Study: The wastewater created as a result of stone cutting industries enters some pools for re-consumption so that its suspended solids settle by gravity. By taking to account the high volume of water and sludge, treatment of wastewater and removal of sludge cause many problems for stone cutting units. The objective of this study was to determine the quality of wast...
متن کاملSurvey of materials for nanoskiving and influence of the cutting process on the nanostructures produced.
This paper examines the factors that influence the quality of nanostructures fabricated by sectioning thin films with an ultramicrotome ("nanoskiving"). It surveys different materials (metals, ceramics, semiconductors, and conjugated polymers), deposition techniques (evaporation, sputter deposition, electroless deposition, chemical-vapor deposition, solution-phase synthesis, and spin-coating), ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science and Education of the Bauman MSTU
سال: 2013
ISSN: 1994-0408
DOI: 10.7463/0313.0541420