منابع مشابه
Mycotoxin tolerances in foodstuffs.
In most countries general legislation on food (and feed) prohibits the sale of products containing poisonous or harmful substances, which would include relevant mycotoxins as well. So far only aflatoxin has been dealt with specifically in legislation. The aflatoxin control may include all foods (and feeds) but is limited in most countries to certain commodities likely to be heavily contaminated...
متن کاملSome Basics on Tolerances
In this paper we deal with sensitivity analysis of combinatorial optimization problems and its fundamental term, the tolerance. For three classes of objective functions (Σ,Π,MAX) we give some basic properties on upper and lower tolerances. We show that the upper tolerance of an element is well defined, how to compute the upper tolerance of an element, and give equivalent formulations when the u...
متن کاملThe Language of Tolerances†
Dimensional tolerancing is a language used to communicate product quality specifications. Effective communication using this language relies on there being a common, shared meaning for tolerances. By this measure, the language of tolerances defined in modern standards does not support good communication. Some reasons for this are: the evolution of technology; the lack of research on tolerances ...
متن کاملTolerances Applied in Combinatorial Optimization
In this paper we deal with sensitivity analysis of combinatorial optimization problems and its fundamental term, the tolerance. For three classes of objective functions (Σ,Π,MAX) we give some basic properties on upper and lower tolerances. We show that the upper tolerance of an element is well defined, how to compute the upper tolerance of an element, and give equivalent formulations when the u...
متن کاملMathematical Programming Glossary Supplement: Tolerances
Whenever we base some decision on a comparison of numerical values, we must consider the impurity of those values. Thus, if a decision depends on whether v = 0, we instead test if |v| ≤ τ , where τ is some small value called a tolerance. More generally, for a particular comparison of the form v = V , we define two tolerances: absolute and relative, denoted τa and τr, respectively. Then, we test...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Optical Engineering
سال: 2003
ISSN: 0091-3286
DOI: 10.1117/1.1562173