Servomechanism Using Traction Drive. 1st Report. Measurement of basic characteristics and proposal for slip-speed feedback compensation.
نویسندگان
چکیده
منابع مشابه
Intelligent-speed-increasing Spindle Using Traction Drive
INTRODUCTION Recently, a milling for die using a small end mill of diameter less than 1 mm is increased, because sizes of plastic mold parts such as connectors for an IT and an electronics becomes micro extremely. In general, a tool life is long and a good cut surface is obtained as a cutting speed is high. A speed-increasing spindle, which is attached to a shank may be used to increase the cut...
متن کاملA Current-Based Output Feedback Sliding Mode Control for Speed Sensorless Induction Machine Drive Using Adaptive Sliding Mode Flux Observer
This paper presents a new adaptive Sliding-Mode flux observer for speed sensorless and rotor flux control of three-phase induction motor (IM) drives. The motor drive is supplied by a three-level space vector modulation (SVM) inverter. Considering the three-phase IM Equations in a stator stationary two axis reference frame, using the partial feedback linearization control and Sliding-Mode (SM) c...
متن کاملApplication of Speed Estimation Techniques for Induction Motor Drives in Electric Traction Industries and vehicles
Induction motors are the most commonly used in the traction industries and electric vehicles, due to their low primary cost, low maintenance costs, and good performance. Speed identification is needed for the induction motor drives. However, using of speed sensors in the induction motor drives is associated with problems such as, extra cost, reduced reliability, added mounting space, etc.. Ther...
متن کاملAssessment of Dynamic Load Equations Through Drive Wheel Slip Measurement
Many parameters such as dynamic load of tractor drive wheels influence the traction of tractors. An increase in dynamic load of drive wheel increases the net traction, but excess dynamic load decreases the tractive efficiency that must be avoided. Development of tractor-mounted implements due to good maneuvering and weight transfer from front axle to rear axle led to effective performance of tr...
متن کاملIterative Feedback Tuning (IFT) of Head Positioning Servomechanism in Hard Disk Drive
Actuators used in hard disk drives (HDD) are produced en mass and therefore their dynamic properties vary within a given tolerance bound. A nominal model representing the batch of actuators is used to design the head positioning servomechanism. Equal performance can not be expected for all actuators when such controller is used. Disk drive servomechanism is expected to provide performance with ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1996
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.62.141