Separated-Flow Noise of a Flat Plate : 1st Report, Noise Characteristics and Generation Mechanism
نویسندگان
چکیده
منابع مشابه
Empirical study of flat plate trailing edge flow and noise
This paper presents results of an empirical study on the flow and noise generated by the trailing edge of a flat plate encountering low turbulence fluid flow. Simultaneous measurements of flow and far-field noise data have been taken in an anechoic wind tunnel at the University of Adelaide. Velocity data about the trailing edge and in the wake have been measured using hot-wire anemometry. These...
متن کاملStability Analysis for Wake Flow Behind a Flat Plate
Neutral stability limits for wake flow behind a flat plate is studied using spectral method. First, Orr-Sommerfeld equation was changed to matrix form, covering the whole domain of solution. Next, each term of matrix was expanded using Chebyshev expansion series, a series very much equivalent to the Fourier cosine series. A group of functions and conditions are applied to start and end points i...
متن کاملOn the aeroacoustic tonal noise generation mechanism of a sharp-edged plate.
This letter presents an experimental study on the tonal noise generated by a sharp-edged flat plate at low-to-moderate Reynolds number. Flow and far-field noise data reveal that, in this particular case, the tonal noise appears to be governed by vortex shedding processes. Also related to the existence of the tonal noise is a region of separated flow slightly upstream of the trailing edge. Hydro...
متن کاملStability Analysis for Wake Flow Behind a Flat Plate
Neutral stability limits for wake flow behind a flat plate is studied using spectral method. First, Orr-Sommerfeld equation was changed to matrix form, covering the whole domain of solution. Next, each term of matrix was expanded using Chebyshev expansion series, a series very much equivalent to the Fourier cosine series. A group of functions and conditions are applied to start and end points i...
متن کاملHigh Reynolds Number Analysis of Flat Plate and Separated Afterbody Flow Using Non-linear Turbulence Models
The ability of the three-dimensional Navier-Stokes method, PAB3D, to simulate the e ect of Reynolds number variation using non-linear explicit algebraic Reynolds stress turbulence modeling was assessed. Subsonic at plate boundary-layer ow parameters such as normalized velocity distributions, local and average skin friction, and shape factor were compared with DNS calculations and classical theo...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1980
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.46.1055