Sensorless Control Analysis of Electric Motor Drives Based on High-Frequency Signal Injection and Its Simulation Verification

نویسندگان

چکیده

The subject of this research is the sensorless control method verification an asynchronous motor by a simulation in area low speed (up to 5 Hz) via high-frequency analog signal injection method. implementation continuous simpler when compared with discrete injection; however, has more advantages processing. injected will be superimposed on main stator voltage. response manifested mainly based asymmetries motor, which are given design motor. influence inductance LS suppressed suitable elimination since asymmetry undesirable for rotor position detection. caused slotting used detect position. less slots inclined, stronger asymmetry. Therefore, verify estimation as realistically possible, mathematical model including due magnetic core saturation and slotting, been designed order get close possible real condition. Thus, chapter “Asymmetry Creation Rotor Slotting” describes phenomenon detail. Subsequently, INFORM detection implemented defined chapter: “Rotor Position Estimation Based HF Signal Injection.” Given fact that undesirable, he error reaches up 10%; therefore, saturations convenient After filtering out these asymmetries, accuracy achieved maximum 0.05 rad, representing 1%. inaccuracy directly proportional rotation speed, it also computing power, processing frequency, complexity algorithm. present paper serves essentially basis effectiveness efficiency other methods.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Combination of voltage model and high-frequency signal injection for sensorless permanent magnet synchronous motor drives

The paper proposes a method for the rotor speed and position estimation of permanent magnet synchronous motors, applicable in a wide speed range including standstill. A modified voltage model is used at high speeds, and it is combined with a high-frequency signal injection technique at low speeds. The fast dynamic response of the voltage model is thus augmented with the steady-state accuracy of...

متن کامل

Sensorless Model Reference Adaptive Control of DFIG by Using High Frequency Signal Injection and Fuzzy Logic Control

In this paper, a new sensorless model reference adaptive method is used for direct control of active and reactive power of the doubly fed induction generator (DFIG). In order to estimate the rotor speed, a high frequency signal injection scheme is implemented. In this study, to improve the accuracy of speed estimation, two methods are suggested. First, the coefficients of proportional-integral ...

متن کامل

Dynamic Performance Analysis of High-Frequency Signal Injection Based Sensorless Methods for Interior Permanent Magnet Synchronous Motors

This paper focuses on three commonly used sensorless methods based on high-frequency signal injection; namely, the rotating sinusoidal injection in the stationary reference frame, the pulsating sinusoidal injection in the estimated synchronous reference frame, and the pulsating square wave injection in the estimated synchronous reference frame. Although these methods have found applications in ...

متن کامل

Sensorless Control of Induction Motor Drives

rotor field orientation stator field orientation stator model rotor model MRAS, observers, Kalman filter parasitic properties field angle estimation Abstract — Controlled induction motor drives without mechanical speed sensors at the motor shaft have the attractions of low cost and high reliability. To replace the sensor, the information on the rotor speed is extracted from measured stator volt...

متن کامل

MRAS based Speed Control of sensorless Induction Motor Drives

Senseless induction motor drives are widely used in industry for their reliability and flexibility, particularly in hostile environment. However, the performance of many of previously developed observer based speed sensors in very low speeds of IM drives was not satisfactory. In this paper we present two types of MRAS based speed estimators, one based on the rotor flux and the other based on th...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Actuators

سال: 2022

ISSN: ['2076-0825']

DOI: https://doi.org/10.3390/act11110317